So I've recently discovered an unplugged USB drive will cause PBS to spam IO errors to a log file until it fills the hard drive and borks itself so I figured I would adjust the logrotate settings to include a maxsize directive to logrotate, only...
Hé là! On dirait que vous faites face à une situation délicate. Si vos disques SAS ne s'affichent pas, mais que les disques SATA fonctionnent correctement, le problème peut être lié à la configuration de votre fond de panier ou de votre...
This one was updated several times during the last 12 months: https://github.com/Corsinvest/cv4pve-autosnap
For me it works as documented and these snapshots are fully integrated in the PVE-Webgui too.
---
For non-PVE ZFS datasets I use...
I would say start with a single node, but also try a cluster setup before going into production. I would say that Proxmox has feature parity comparing to VMware looking from a single node. Looking at the cluster level, Proxmox still misses a few...
I don't think so: https://blog.westerndigital.com/wp-content/uploads/2020/10/wd-red-family.png
But yes, it should get replaced, in my opinion.
With enough redundancy on the vdev level you could run a "long self-test" and then wait for...
OK so it happened again and this time I was able to preserve the logs before deleting them. Basically an external USB was unplugged and PBS went crazy writing IO errors to the log many times a second...
2025-12-23T11:46:14+08:00: Starting...
Hi,
This is a great thread for how to set up coral/gasket, and I have used the instructions here to successfully build and install gasket without error.
My problem is that once I start frigate, proxmox kernel panics and crashes.
I'm at a loss as...
Eigentlich ist Corosync recht Robust und einfach, außer bei Netzwerklatenz.
Du hast da verschiedene öffentliche IPs maskiert. Wenn die beiden Nodes bei einem Provider in einem RZ stehen, dann kann das gut funktionieren, obwohl ich immer von so...
Wo der Order ist kommt darauf an wie du es installiert und konfguriert hast. Du kannst SAMBA wenn gewünscht direkt im paperless CT laufen lassen.
Man kann auch ein bind mount nehmen aber das ist wesentlich komplizierter, vor allem für Anfänger...
Ah, thank you, I didn't notice that task history.
Here is the relevant logs:
INFO: Starting Backup of VM 405 (lxc)
INFO: Backup started at 2025-12-31 02:44:53
INFO: status = running
INFO: CT Name: tunarr
INFO: including mount point rootfs ('/')...
There is a lengthy discussion of what is happening at https://www.reddit.com/r/Proxmox/comments/1j2zrol/the_reasons_for_poor_performance_of_windows_when/ And there also is a blog post at...
Wie ist es bezüglich der /etc/pve/.members Dateien? Jeweils zuvor wieder die verschwundenen IPs einpflegen?
Oder regelt sich das automatisch mittels des von dir (@Falk R. ) beschriebenen "Reset"?
When moving from standalone nodes to a cluster, the network you have to be most concerned about is the cluster network. The cluster network carries the Corosync traffic, and best practice is to have a dedicated 1Gbps network for just the cluster...