Latest activity
-
Ssilverstone replied to the thread Bond & Bridge Interfaces - Undesired Behavior.Using an Interface which does NOT exist for bond-primary Setting (enp1s0f0np0) Use ifdown bond0 to actually trigger the Issue: if the Bond already exists when the Configuration is reloaded, then the Bond will still exists afterwards. Test...
-
-
Jjanus57 replied to the thread Error to Import VMDK to PVE9.Hi, What does qemu-img info [filename] say about your vmdk image ? Best regards,
-
Ssilverstone posted the thread Bond & Bridge Interfaces - Undesired Behavior in Proxmox VE: Installation and configuration.I started migrating from pure Bridge Network Setup towards Bond based Network Setup on several of my Hosts now, after I accidentally created a Network Loop by plugging in multiple NICs (physical Interface connected to vmbr0 in Proxmox Network...
-
HHeracleos reacted to e78413b1's post in the thread [SOLVED] Super slow, timeout, and VM stuck while backing up, after updated to PVE 9.1.1 and PBS 4.0.20 with
Like.
Kernel 6.17.4-2-pve is now available in the no-subscription repositories, so I updated, unpinned the old 6.14.11 kernel, and rebooted all nodes. The first backup job went fine. I will report back on friday if any issues arise. Until then, thanks... -
Jjanus57 replied to the thread Disk space usage is not freed up.Hi, Yes, maybe but it's not official nor in the GUI. For backup appliance I personnaly will never run any scripts which are not provided by the vendor. Best regards,
-
Sseanr22a replied to the thread Opt-in Linux 6.17 Kernel for Proxmox VE 9 available on test & no-subscription.I'm not sure it gets that far. It goes through all the standard Supermicro bios console messages, after the last bios message I should get the proxmox selection of kernel to boot or just wait a second and it boots automatic but after the last...
-
GGMBauer replied to the thread Proxmox won't complete the reboot.Imho is this a known bug caused by an very old firmware of the Broadcom-nics.
-
GGMBauer replied to the thread Immich LXC Server bringt CPU auf 100°C sobald immich Aufgaben laufen.Also zuerst mal das wichtigste. DAS ist kein Server. Das ist bestenfalls und auch nur mit ganz viel Glück ein Arbeitsplatz-PC mit einer lausigen, weil unzuverlässigen Kühlung und einer noch lausigeren Throttelung. Normalerweise dürfte ein PC...
-
Tealk replied to the thread Proxmox Backup Server mit S3.Ne da hab ich ne Maschine bei Hetzner angemietet. Bzw aktuell 2 Eine für PVE und eine zweite PBS. Aktuell 50 VM's die Täglich gesichert werden da jede Software seine eigene VM bekommt. -
JJohannes S replied to the thread Storage / View confusion / icon upgrade suggestion.Bug reports and feature requests ahould be filed on bugzilla.proxmox.com
-
Ssightkick replied to the thread Encountered a issue reboot when upgrading pve version 8 to 9..The solution for me is found! It wasn´t the controller. The problem ist the Kerner >6.5 with the Broadcom network interface cards. The are not compatible. If you disable them in system Bios the machine ist booting fine (PVE9) without any error...
-
JJohannes S reacted to fstrankowski's post in the thread First Proxmox Installation Questions with Like.
Depends on your requirements for data safety. Thats solely on your discretion. Technically it works either way. Thats totally subjective. Personally i'd go for way less power consumption and way less old hardware, but the setup should work just...
-
JIn your situation I would use the two 4TB drives in a mirror, and I would install there and use the extra space for data storage, backup space, etc. I would put the VM storage on the NVME drive. It would be better if there were two NVME drives...
-
JRAIDz1 and HDDs are the exact opposite of getting high IOPS for active VM disks. Proxmox does not need an SSD for itself as speed is not important and it writes a lot (so and old HDD is fine). Maybe search the forum a bit about...
-
JJohannes S reacted to janus57's post in the thread VM incremental backups much larger than expected on PBS. with Like.
Hi, If I'm not mistaken, you forgot one critical data; for this, I assume BORG works at the file system level and not at the VM level. If that is the case, the BORG will be better at locating the modified areas in the current FS. If your VM...
-
JJohannes S reacted to SteveITS's post in the thread VM incremental backups much larger than expected on PBS. with Like.
> for modified files → total changes ~7 GB This sounds like you found the "new" usage found at the end of the 4 hours, not the total amount written to disk during that time? If one rewrote the entire disk with the same bits, per my...
-
JJohannes S reacted to janus57's post in the thread VM incremental backups much larger than expected on PBS. with Like.
Hi, I don't know how you make the connection between a 40GB dirty bitmap and bad deduplication. Can you explain more and/or give more details, because it's seem you seek for a specific answer without telling the true question. Best regards,
-
Ssightkick replied to the thread Proxmox won't complete the reboot.The solution for me is found! It wasn´t the controller. The problem ist the Kerner >6.5 with the Broadcom network interface cards. The are not compatible. If you disable them in system Bios the machine ist booting fine without any error AND with...
-
SSteffenDE replied to the thread [SOLVED] Templates für /usr/bin/pmg-smtp-filter.Meiner Recherche nach gibt es leider keinen offiziellen Templatepfad für pmg-smtp-filter selbst, d. h. die Modifikation ist nicht updatesicher.
-
Mmsantosn posted the thread proxmox-backup-client - Error: Is a directory (os error 21) in Proxmox Backup: Installation and configuration.I am doing a PoC of PBS to backup files from a server. I have setup PBS 4.1.0 and from that end seems fine, but I installed a client on Ubuntu 22.04, I have tried these two: -...
