Latest activity
-
JJordiPalet posted the thread General protection fault ... in Proxmox VE: Installation and configuration.Hi, One of my servers, every few weeks get stuck and needs to be rebooted. CPU is 12 x 13th Gen Intel(R) Core(TM) i7-1355U (1 Socket) with 96GB DDR5 (non-ECC) Proxmox 9.1.2 - kernel 6.17.2-1-pve (it has been happening the same with previous...
-
LLKo replied to the thread [SOLVED] Super slow, timeout, and VM stuck while backing up, after updated to PVE 9.1.1 and PBS 4.0.20.They definitly know how to communicate efficiently over at netdev :D Trying 6.17.11-4-test-pve now and will build 6.18 + the patches Eric mentioned once finished with that (the ubuntu 6.19-rc1 build is non-existent for amd64 atm). I wasn't able...
-
AAtkatla replied to the thread [suggestion] Folders for VMS.Hi, but pools seems to be a flat architecture? like datacenter-cluster |-- businessunitA - system 1 - production-vms |-- businessunitA - system 1 - dev-vms |-- businessunitA - system 2 - production-vms |-- businessunitB - system 1 -...
-
DThanks for your reply , my problem solved here's how : 1st step: increase/resize disque from GUI console 2nd step : Extend physical drive partition check free space : $sudo fdisk -l $growpart /dev/sda 3 (Extend physical drive partition...
-
mariol replied to the thread Replacing all drives on clustered nodes.Basically yes. But be careful. You probably mean you will move everything to NodeA. NodeA remains active while you then remove NodeB from Datacenter>Storage. So you delete the Zpool on the node where there is no longer any data/VMs. -
CHello, I have a cluster with SDN configured, EVPN for East/West communication and regular BGP towards external network elements. This was working fine for some time, but today I can't receive traffic from external network in a VM (ping to a...
-
A status update on this: Two corosync parameters that are especially relevant for larger clusters are the "token timeout" and the "consensus timeout". When a node goes offline, corosync (or rather the totem protocol it implements) will need to...
-
dakralex replied to the thread HA affinity problem (?).Thanks! If it's possible, it would be great to have a more complete reproducer for this to investigate the issue. The names can be changed, the only important part is that the changed names have the same alphabetical ordering (e.g. SN140 ->... -
IIsThisThingOn replied to the thread ZFS storage is very full, we would like to increase the space but....On a serious note though, how old is your hardware RAID @cybermod? What would you do, if it fails tomorrow? These are IMHO questions you have to ask yourself when running Hardware RAID, since it is not always that easy to reimport a pool as with...
-
IIsThisThingOn replied to the thread ZFS storage is very full, we would like to increase the space but....I would argue that it is the best tool for MOST use cases. Just because a lot of people use a hammer with the claw side to hammer in a nail, doesn't mean it isn't the greatest to tool to hammer in a nail. Edit for all the hardware RAID fanboys...
-
OOnslow reacted to Unsubtle9244's post in the thread Can't backup 1 VM to Proxmox Backup Server with
Like.
Hi, I also had a similar problem and did not find the solution at first. For testing I disabled fs-freeze flag (uncheck "Freeze/thaw guest filesystems on backup for consistency" in QEMU Guest agent section of VM options). Backup went well... -
cheiss replied to the thread Promox Network Interface.Hi, (assuming also a /24 like the other,) do you have a gateway for this network? 172.16.14.0/24 is one subnet, 172.16.15.0/24 a separate one. So essentially you need some router for this subnet. This isn't really specific to Proxmox VE, but... -
Kksbsrene replied to the thread How does the licensing work?.Thank you so much, that was very helpful :)
-
IIsThisThingOn reacted to alexskysilk's post in the thread ZFS storage is very full, we would like to increase the space but... with Like.
A word about spares: spares should be avoided, especially for your use case. The reason for that is that spares are spinning the whole time alongside with your "operating" drives, which means they are having miles put on them without any real...
-
KFirst of, small but important difference: the primary license of Proxmox products is the AGPLv3. You are buying subscriptions :) The Subscription for Proxmox VE needs to match the number of physical CPUs in the server. That's why you have a few...
-
aaron replied to the thread How does the licensing work?.First of, small but important difference: the primary license of Proxmox products is the AGPLv3. You are buying subscriptions :) The Subscription for Proxmox VE needs to match the number of physical CPUs in the server. That's why you have a few... -
Iinformant replied to the thread [SOLVED] Cluster mit ? und grau aber CPU RAM Anzeige in Übersicht funzt jedoch kein Graph.Hallo, anbei die Log, Fehler kam die Nacht, bis in der Nacht war nichts grau. Nachdem der Fehler aufgetreten ist, sieht die Serviceliste so aus... Siehe Screenshot im Anhang. Log pvestat sagt gestern Abend: Dec 16 18:32:53 pegasus...
-
-
A status update on this: Two corosync parameters that are especially relevant for larger clusters are the "token timeout" and the "consensus timeout". When a node goes offline, corosync (or rather the totem protocol it implements) will need to... -
Kksbsrene posted the thread How does the licensing work? in Proxmox VE: Installation and configuration.I purchased some licenses for migrating from VMware to Proxmox. We have a cluster of 3 nodes, each with 2 CPUs. I received 6 individual licenses from Proxmox, but they are all single-socket licenses. Where can I have this changed?
-
Ddworkin replied to the thread Creating another linux bridge.Apologies news, I did not ask the right question. How do I create a bridge that gives access to my home 10.xxx.xxx.xxx network but not the internet or am I asking the wrong question and this should be done on my unifi gateway switch?
