Win10 and Virtio drivers

[michaelf]

Hello,

A couple of weeks ago I downloaded the latest virtio iso and was able to deploy Win10 VM without a single issue - I just chose the virtio driver from the attached ISO and Windows completed installion successfully (VM name = Win10L):



Today I tried to create another Win10 VM and got puzzled by the following fact: when I select the driver - as far as I remember - that I had been using during my first installation, Windows starts loading it but then says ~ "Can't proceed - no disks found":





What am I doing wrong here providing I have already managed to get Windows installed??? Maybe I'm selecting a wrong driver?

Thank you in advance,
Michael

 

[bbgeek17]

Did you compare the hardware tabs of two VMs? Or "qm config [ID]" outputs?
Perhaps you don't have the disks, or they are not connected to the correct controller?

---

Blockbridge : Ultra low latency all-NVME shared storage for Proxmox - https://www.blockbridge.com/proxmox

 

[michaelf]

No, all is exactly the same!