Hallo zusammen,
ich verweifel bald ;-) folgendes Problem. Habe einen Dedi-Server bei myloc eine Haupt IP, 3zusätzliche IP´s. Habe Proxmox installiert und wie folgt die /etc/network/interfaces angepasst:
Neustart alles läuft, VM kann erstellt und gestartet werden.
VM wird reibungslos Installiert. Aber wie kann ich jetzt die IP der VM setzten . ......
Wenn ich eth0 mit IP, Subnetz und Gateway anpasse funktioniert es nicht ....
muss ich noch was anderes machen ?
Werde da bald nicht schlau raus .... bei Hetzner konnte ich MAC adressen abrufen und diese eingeben und es ging, bei myloc geht dies wohl nicht
ich verweifel bald ;-) folgendes Problem. Habe einen Dedi-Server bei myloc eine Haupt IP, 3zusätzliche IP´s. Habe Proxmox installiert und wie folgt die /etc/network/interfaces angepasst:
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
auto lo
iface lo inet loopback
iface eth0 inet manual
auto vmbr0
iface vmbr0 inet static
address 62.141.42.xx
netmask 255.255.255.0
gateway 62.141.42.1
bridge_ports eth0
bridge_stp off
bridge_fd 0
up ip route add 37.157.255.xxx/32 dev vmbr0
up ip route add 62.141.32.xxx/32 dev vmbr0
up ip route add 62.141.32.xxx/32 dev vmbr0
Neustart alles läuft, VM kann erstellt und gestartet werden.
VM wird reibungslos Installiert. Aber wie kann ich jetzt die IP der VM setzten . ......
Wenn ich eth0 mit IP, Subnetz und Gateway anpasse funktioniert es nicht ....
muss ich noch was anderes machen ?
Werde da bald nicht schlau raus .... bei Hetzner konnte ich MAC adressen abrufen und diese eingeben und es ging, bei myloc geht dies wohl nicht