Hello,
I suspect an issue with my TP-LINK switch (case + thread open with tp-link), but i want to validate my proxmox configuration too.
Basically, I have a proxmox server with a couple of VMs/containers running, including my Pfsense who act as L3 router for my inside network and as internet router.
For informations here is my proxmox configuration :
My VMBR2 bridge is "VLAN aware" and bridge to enp4s0 physical port.
My VM is set to TAG frames with VID 2.
If i capture the traffic directly on my proxmox host, I can see my VLAN tag (on physical and bridge interfaces)
If I capture the traffic on the switch (monitor session) I cannot see the VLAN ID anymore,
Of course I got nothing if I run a packet capture on my pfsense as the frame is probably drop because of the VID missing
Here is the switch configuration :
interface gigabitEthernet 1/0/24
switchport general allowed vlan 2,10-14,99 tagged
no switchport general allowed vlan 1
T1600G-28TS#sh interface switchport gigabitEthernet 1/0/24
Port Gi1/0/24:
PVID: 1
Member in LAG: N/A
Link Type: General
Member in VLAN:
Vlan Name Egress-rule
---- ----------- -----------
2 N/A Tagged
10 N/A Tagged
11 N/A Tagged
12 N/A Tagged
13 N/A Tagged
14 N/A Tagged
99 N/A Tagged
As I said,it's probably a switch issue, but if someone see something wrong with my proxmox configuration please let me know.
Thanks,
I suspect an issue with my TP-LINK switch (case + thread open with tp-link), but i want to validate my proxmox configuration too.
Basically, I have a proxmox server with a couple of VMs/containers running, including my Pfsense who act as L3 router for my inside network and as internet router.
For informations here is my proxmox configuration :
My VMBR2 bridge is "VLAN aware" and bridge to enp4s0 physical port.
My VM is set to TAG frames with VID 2.
If i capture the traffic directly on my proxmox host, I can see my VLAN tag (on physical and bridge interfaces)
If I capture the traffic on the switch (monitor session) I cannot see the VLAN ID anymore,
Of course I got nothing if I run a packet capture on my pfsense as the frame is probably drop because of the VID missing
Here is the switch configuration :
interface gigabitEthernet 1/0/24
switchport general allowed vlan 2,10-14,99 tagged
no switchport general allowed vlan 1
T1600G-28TS#sh interface switchport gigabitEthernet 1/0/24
Port Gi1/0/24:
PVID: 1
Member in LAG: N/A
Link Type: General
Member in VLAN:
Vlan Name Egress-rule
---- ----------- -----------
2 N/A Tagged
10 N/A Tagged
11 N/A Tagged
12 N/A Tagged
13 N/A Tagged
14 N/A Tagged
99 N/A Tagged
As I said,it's probably a switch issue, but if someone see something wrong with my proxmox configuration please let me know.
Thanks,