Usb-Redirector using on guest

[tsaenger]

Hi,

i try to use the redirector for using my usb-FritzCard.
i installed Server and client on both systems.
i also created an connection, but my capi will not access the usb-device.
lsusb also won't show the new device.
is there something i forgot to do?

thanks a lot

tobias

 

[tsaenger]

Hi,
i forgot to use the connect-command.
now i can see the device by using lsusb, but capi tells me:

# capiinit
ERROR: controller 1: firmware load failed - Device or resource busy (16)


!! CHECK THE KERNEL MESSAGES BEFORE SENDING MAIL !!

kern.log say

Apr 24 07:53:43 hw kernel: [30109.108042] usb 2-1: new full speed USB device using usb-vhci-driver and address 2
Apr 24 07:53:43 hw kernel: [30109.512179] usb 2-1: configuration #1 chosen from 2 choices
Apr 24 07:53:43 hw kernel: [30109.518493] fcusb2: Driver 'fcusb2' attached to fcusb2-stack. (152)
Apr 24 07:53:43 hw kernel: [30109.518508] kcapi: Controller [001]: fcusb2-0002 attached
Apr 24 07:55:07 hw kernel: [30193.829215] fcusb2: USB I/O error, code -104!
Apr 24 07:55:07 hw kernel: [30193.829589] fcusb2: Firmware does not respond!
Apr 24 07:55:07 hw kernel: [30193.829960] kcapi: card [001] down.
Apr 24 07:56:04 hw kernel: [30250.256040] usb-vhci-driver usb-vhci-driver: Unlink after no-IRQ?  Controller is probably using the wrong IRQ.
Apr 24 07:56:04 hw kernel: [30250.256049] fcusb2: USB I/O error, code -110!
Apr 24 07:56:04 hw kernel: [30250.256504] fcusb2: Firmware does not respond!
Apr 24 07:56:04 hw kernel: [30250.256911] kcapi: card [001] down.
Apr 24 07:57:34 hw kernel: [30340.192038] fcusb2: USB I/O error, code -110!
Apr 24 07:57:34 hw kernel: [30340.192407] fcusb2: Firmware does not respond!
Apr 24 07:57:34 hw kernel: [30340.192820] kcapi: card [001] down.

Thanks for help

tobias