upgraded to bigger ssd no network

[jhmc93]

Hello,
So I've cloned my 512gb SSD to a 1tb SSD that has proxmox installed on it and after that I resized the drive to make use of the space, now that I've installed it back into my proxmox pc, it boots up fine, but it doesn't allow me to access the pve gui or even ssh into it, It may be a network problem???
If it is can someone help, the problem I have is I've got pci-e passthrough on so when I boot up I get the following screen:


I really would like help asap as I'm wanting to get this running possibly today

 

[Impact]

Did you use PCI(e) passthrough? Also try to boot with debug nomodeset.

 

[jhmc93]

Did you use PCI(e) passthrough? Also try to boot with debug nomodeset.

I did, do I need to use the install to use debug?, if so I might as well just reinstall pve as I've backed up the vm's, but I wondered if I could fix the problem, because didn't want to go through igpu setup again

 

[Impact]

No need to reinstall, just disable virtualization in the UEFI. After boot change the device and make sure it still has its own IOMMU group.

 

[jhmc93]

No need to reinstall, just disable virtualization in the UEFI. After boot change the device and make sure it still has its own IOMMU group.

I'm still learning proxmox so at the moment I need guiding on how to do this

 

[Impact]

Please stop quoting every message. How to get into the UEFI is very dependent on your mainbaord. Its manual will tell you the key to press to get into it. Where exactly to find the virtualization options is hard to say as well. As for the IOMMU groups see here. If anything else is unclear let me know and I'll try to clarify.

 

[jhmc93]

I'll just reinstall can't be doing with all the messing, just thought there was an easier fix then what you said