Second ISCSI Target has no LUNs in Base Volume?

[ejc317]

There's nothing in drop down ... I uninstalled multipath already but want to check what else could be the issue ...

 

[ejc317]

So when I do vgscan or VGS - it says found duplicate -

when I do iscsiadm -m node -L alli

It shows error loggin into the interfaces connected to the 2nd iscsi target ... i searched but found no clear solution

Also, on the SAn side, there are open iSCSI sessions to both volumes ...

 

[hotwired007]

What SAN are you using?

 

[ejc317]

OSNexus

Tried with Openfiler - same issue.

My target #1 is ID 1 LUN 1
My target #2 is ID 2 LUN 2

I assume it's because the LUN is 2?

 

[snowman66]

AFAIK you need to check checkbox "Use LUN directly" otherwise the list is empty.

 

[ejc317]

I did no change

 

[snowman66]

Did you use the correct initiator name?

cat /etc/iscsi/initiatorname.iscsi

 

[ejc317]

Did you use the correct initiator name?

cat /etc/iscsi/initiatorname.iscsi

Errr yes this is not helpful. LIke I said there are sessions open. If wrong initiator - it won't open ?