Good day All,
I am trying to create a private network that is accessible by all VMs (on that network) across my Proxmox cluster. I thought SDN would be my solution for that and because I want it accessible over all the nodes, it has to be a VLAN zone.
Now, my problem comes in when I apply the SDN config for the newly created VLAN10 (same name for zone and vnet). My test cluster is a 4 node setup, with 3x Dell servers and 1x SuperMicro server. All 4 of them have the ConnectX-4 NIC and the 25Gbps connected ports are set up on vmbr0. When I created the Zone, I also used vmbr0 as the bridge. The error I am getting:
This error only occurs on the SuperMicro server.
Since my PROD cluster consist of only SuperMicro servers with ConnectX-4 cards, I suspect I will have the same problem on all those nodes.
Not sure if this matters, but all 4 nodes where running PVE7.4 and have been manually upgraded to PVE8.2. Here is the /etc/network/interfaces file for the node with the error.
I am trying to create a private network that is accessible by all VMs (on that network) across my Proxmox cluster. I thought SDN would be my solution for that and because I want it accessible over all the nodes, it has to be a VLAN zone.
Now, my problem comes in when I apply the SDN config for the newly created VLAN10 (same name for zone and vnet). My test cluster is a 4 node setup, with 3x Dell servers and 1x SuperMicro server. All 4 of them have the ConnectX-4 NIC and the 25Gbps connected ports are set up on vmbr0. When I created the Zone, I also used vmbr0 as the bridge. The error I am getting:
Code:
netlink : error: netlink: enp129s0f0np0.10: cannot create vlan enp129s0f0np0.10 10: interface name exceeds max length of 15This error only occurs on the SuperMicro server.
Since my PROD cluster consist of only SuperMicro servers with ConnectX-4 cards, I suspect I will have the same problem on all those nodes.
Not sure if this matters, but all 4 nodes where running PVE7.4 and have been manually upgraded to PVE8.2. Here is the /etc/network/interfaces file for the node with the error.
Code:
auto lo
iface lo inet loopback
iface enp129s0f0np0 inet manual
iface enp197s0f0 inet manual
iface enp197s0f1 inet manual
auto vmbr0
iface vmbr0 inet static
address 102.xxx.xxx.18/23
gateway 102.xxx.xxx.1
bridge-ports enp129s0f0np0
bridge-stp off
bridge-fd 0
iface usb0 inet manual
iface enp129s0f1np1 inet manual
auto vmbr1
iface vmbr1 inet manual
bridge-ports enp129s0f1np1
bridge-stp off
bridge-fd 0
source /etc/network/interfaces.d/*