Hello Everyone,
I have a cluster with two nodes and a SAN with FC, I have successfully configured a LUN with multipath.
If I configure a new LUN on my SAN I can't be able to see it, only after reboot the node I can see it.
There is a command for update disks without reboot the host?
I searched about this but I don't found the solution.
Sorry for the question but I am new about ProxMox.
Regards
I have a cluster with two nodes and a SAN with FC, I have successfully configured a LUN with multipath.
If I configure a new LUN on my SAN I can't be able to see it, only after reboot the node I can see it.
There is a command for update disks without reboot the host?
I searched about this but I don't found the solution.
Sorry for the question but I am new about ProxMox.
Regards
