pveceph install failed new proxmox 7 install

[Haider Jarral]

I have 3 nodes all same hardware and specs. I was able to install ceph on 2 of my nodes successfully but it only fails on third one and I can't figure why. Any pointers please ?

root@hp2:~# pveceph install
update available package list
start installation
Reading package lists... Done
Building dependency tree... Done
Reading state information... Done
gdisk is already the newest version (1.0.6-1.1).
ceph-common is already the newest version (17.2.6-pve1).
ceph-fuse is already the newest version (17.2.6-pve1).
Some packages could not be installed. This may mean that you have
requested an impossible situation or if you are using the unstable
distribution that some required packages have not yet been created
or been moved out of Incoming.
The following information may help to resolve the situation:

The following packages have unmet dependencies:
ceph-base : Depends: ceph-common (= 16.2.14-pve1) but 17.2.6-pve1 is to be installed
ceph-mgr : Depends: libsqlite3-mod-ceph (= 16.2.14-pve1) but it is not going to be installed
Depends: librados2 (= 16.2.14-pve1) but 17.2.6-pve1 is to be installed
E: Unable to correct problems, you have held broken packages.
apt failed during ceph installation (25600)


root@hp2:~# pveversion
pve-manager/7.4-17/513c62be (running kernel: 5.15.131-2-pve)
root@hp2:~#

 

[cheiss]

Hi,

can you please post the output of tail -n+0 /etc/apt/sources.list /etc/apt/sources.list.d/*
On a hunch I'd say you have misconfigured package lists.

Also, please post the output of pveversion -v, that's always good to have.

 

[Haider Jarral]

Ok So here is what happened, I wanted to install ceph octopus on all 3 nodes. This node accidentally got quincy setup started and I could not revert it back. So I went with quincy on all 3 nodes and it worked out.

There should be a way to revert if you accidentally start wrong ceph version installation.