Hi,
This isn't a problem unique to proxmox but I wanted to check if the SMART info in the 'Disks' view was coming from smartctl?
Reason being, with this controller, you need to use another method to get proper smartctl information.
Is there any way to get the correct information into the GUI? Even if I have to manually map the drives somehow?
Output from smartctl
Output from smartctl with areca
This isn't a problem unique to proxmox but I wanted to check if the SMART info in the 'Disks' view was coming from smartctl?
Reason being, with this controller, you need to use another method to get proper smartctl information.
Is there any way to get the correct information into the GUI? Even if I have to manually map the drives somehow?
Output from smartctl
Code:
root@pve:~/scripts/diskhealth# smartctl -q noserial -a /dev/sdf
smartctl 6.6 2016-05-31 r4324 [x86_64-linux-4.15.18-16-pve] (local build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Vendor: WDC
Product: WD2502ABYS-18B7A
Revision: R001
User Capacity: 250,000,000,000 bytes [250 GB]
Logical block size: 512 bytes
Rotation Rate: 10000 rpm
Device type: disk
Transport protocol: Fibre channel (FCP-2)
Local Time is: Mon Aug 12 17:35:19 2019 BST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
Temperature Warning: Disabled or Not Supported
=== START OF READ SMART DATA SECTION ===
SMART Health Status: OK
Current Drive Temperature: 30 C
Drive Trip Temperature: 25 C
Manufactured in week 30 of year 2002
Specified cycle count over device lifetime: 4278190080
Accumulated start-stop cycles: 256
Elements in grown defect list: 0
Error counter log:
Errors Corrected by Total Correction Gigabytes Total
ECC rereads/ errors algorithm processed uncorrected
fast | delayed rewrites corrected invocations [10^9 bytes] errors
read: 0 0 0 0 0 0.000 0
write: 0 0 0 0 0 0.000 0
Non-medium error count: 0
Device does not support Self Test loggingOutput from smartctl with areca