[SOLVED] Proxmox + pi5+ LTSC 2024 IOT = no network

cemara

Member
Sep 8, 2022
7
0
6
Hi, i figured this is a network issue, so i post here
I'm Trying to run windows on arm on pi5, for a x86 only app.

https://github.com/jiangcuo/Proxmox-Port/wiki/Windows-11-arm64

Managed to boot win11ltsc 2024 iot arm using this guide, but there's 1 thing i cant replicate, the network config, thus the vm says network not found.

virtio=D6:BA:58:C8:B6:60,bridge=e1000,firewall=1

My question is, how exactly do i bridge e1000 nic? do i create a e1000 nic emulation first?proxmox webgui wont even allow me to create that bridge, bridge ports wont allow me to enter e1000..

What i've tried :

Naming Conventions
We currently use the following naming conventions for device names:

Ethernet devices: en*, systemd network interface names. This naming scheme is used for new Proxmox VE installations since version 5.0.

Ethernet devices: eth[N], where 0 ≤ N (eth0, eth1, …) This naming scheme is used for Proxmox VE hosts which were installed before the 5.0 release. When upgrading to 5.0, the names are kept as-is.

Bridge names: Commonly vmbr[N], where 0 ≤ N ≤ 4094 (vmbr0 - vmbr4094), but you can use any alphanumeric string that starts with a character and is at most 10 characters long.

Bonds: bond[N], where 0 ≤ N (bond0, bond1, …)

VLANs: Simply add the VLAN number to the device name, separated by a period (eno1.50, bond1.30)

This makes it easier to debug networks problems, because the device name implies the device type.



  • Installing network driver virtio :
    Virtio : Install redhat vnic using virtio driver, but even with static ip it wont ping outside network, it says no network found.
    E1000, VMWare, Realtek : no drivers found on virtio
 
Last edited:
Solved, i am not sure what went wrong, but i followed this guide and redo the whole thing again,
at first at windows boot it says it wont find the driver, but afterwards it's finally working properly in windows.