Proxmox auf Thinksystem Sr630 mit RAID 930-8i/2GB 12G Raid 5

aerbuqx

New Member
May 8, 2025
1
0
1
Ich möchte auf meinem Raid 5 Proxmox installieren. Jedoch passiert es jedes mal wenn ich proxmox installiere das mir sda missing angezeigt wird . Ich habe schon versucht unter Options im Installer die Größe des erkannten Raid Volumes etwas zu veringern, allerdings hat das auch nix gebracht. Raid ist fehlerfrei initalisiert. Hat jemand dazu eine Idee warum das jedes mal passiert. Gibt es Gegebenheiten die ich vorher geprüft werden müssen bei Hardware Raid 5 ext 4 installation bei Proxmox. Mein Raid arry ist 8tb groß und wird unter lsblk mit 8tb erkannt sda.

(proxinstall:4869): Gtk-WARNING **: 10:44:01.834: Could not load a pixbuf from
This may indicate that pixbuf loaders or the mime database could not be found.
Creating new GPT entries in memory.
Warning: The kernel is still using the old partition table.
The new table will be used at the next reboot or after you
run partprobe(8) or kpartx(8)
GPT data structures destroyed! You may now partition the disk using fdisk or
other utilities.
Warning! Read error 25; strange behavior now likely!
Creating new GPT entries in memory.
Disk is too small to hold GPT data (1 sectors)! Aborting!
Unable to partition harddisk '/dev/sda'
umount: /target/run: no mount point specified.
umount: /target/mnt/hostrun: no mount point specified.
umount: /target/tmp/pkg: no mount point specified.
umount: /target/tmp: no mount point specified.
umount: /target/proc: no mount point specified.
umount: /target/sys/firmware/efi/efivars: no mount point specified.
umount: /target/sys: no mount point specified.
umount: /target: not mounted.
 
Last edited: