Hi there,
I started exploring proxmox in a VM about two weeks ago and I've really been loving it. I installed it on my server last night and ran into a little bit of an issue.
My computer is set to boot into EFI Only. The computer sees the Proxmox 3.4 installation media and successfully completes installation but the moment the computer restarts it cannot detect the installation on the hard disk. On a whim I switched the computer to boot into Legacy Only and proxmox turned right on [with the existing installation] and worked perfectly.
Did I miss something on how to properly install proxmox onto an EFI enabled system?
I tried searching and didn't really come up with any specific instructions other than proxmox should support EFI since version 3.3.
Any help would be appreciated.
I'm using the software on a Lenovo TS440 for what it's worth.
I started exploring proxmox in a VM about two weeks ago and I've really been loving it. I installed it on my server last night and ran into a little bit of an issue.
My computer is set to boot into EFI Only. The computer sees the Proxmox 3.4 installation media and successfully completes installation but the moment the computer restarts it cannot detect the installation on the hard disk. On a whim I switched the computer to boot into Legacy Only and proxmox turned right on [with the existing installation] and worked perfectly.
Did I miss something on how to properly install proxmox onto an EFI enabled system?
I tried searching and didn't really come up with any specific instructions other than proxmox should support EFI since version 3.3.
Any help would be appreciated.
I'm using the software on a Lenovo TS440 for what it's worth.
Last edited: