HI,
I want to use an Atheros Wifi card in a VM.
I tried wiki, but every time I assign the PCI to the VM and then start it, Proxmox loses its network connection.
Atheros AR928x Wifi N Card.
GRUB is configured:
	
	
	
		
Modules are configured:
	
	
	
		
Then i have blacklist the Driver ath9k. And use the Webgui to add the Wificard as Hardware in the VM. If i now start the VM, all Network is lost. I must reboot proxmox...
				
			I want to use an Atheros Wifi card in a VM.
I tried wiki, but every time I assign the PCI to the VM and then start it, Proxmox loses its network connection.
Atheros AR928x Wifi N Card.
GRUB is configured:
		Code:
	
	root@proxmox:~# dmesg | grep -e DMAR -e IOMMU
[    0.016543] ACPI: DMAR 0x000000007BB03FF0 0000A8 (v01                 00000003 BRXT 0100000D)
[    0.112831] DMAR: IOMMU enabled
[    0.247863] DMAR: Host address width 39
[    0.247866] DMAR: DRHD base: 0x000000fed64000 flags: 0x0
[    0.247882] DMAR: dmar0: reg_base_addr fed64000 ver 1:0 cap 1c0000c40660462 ecap 7e3ff0505e
[    0.247885] DMAR: DRHD base: 0x000000fed65000 flags: 0x1
[    0.247897] DMAR: dmar1: reg_base_addr fed65000 ver 1:0 cap d2008c40660462 ecap f050da
[    0.247901] DMAR: RMRR base: 0x0000007b6a9000 end: 0x0000007b6c8fff
[    0.247904] DMAR: RMRR base: 0x0000007d800000 end: 0x0000007fffffff
[    0.247908] DMAR-IR: IOAPIC id 1 under DRHD base  0xfed65000 IOMMU 1
[    0.247911] DMAR-IR: HPET id 0 under DRHD base 0xfed65000
[    0.247913] DMAR-IR: Queued invalidation will be enabled to support x2apic and Intr-remapping.
[    0.250174] DMAR-IR: Enabled IRQ remapping in x2apic mode
[    2.330766] DMAR: No ATSR found
[    2.330865] DMAR: dmar0: Using Queued invalidation
[    2.330871] DMAR: dmar1: Using Queued invalidation
[    2.343661] DMAR: Intel(R) Virtualization Technology for Directed I/OModules are configured:
		Code:
	
	# /etc/modules: kernel modules to load at boot time.
#
# This file contains the names of kernel modules that should be loaded
# at boot time, one per line. Lines beginning with "#" are ignored.
#alle vier aktiviert - 16-7-20
 vfio
 vfio_iommu_type1
 vfio_pci
 vfio_virqfdThen i have blacklist the Driver ath9k. And use the Webgui to add the Wificard as Hardware in the VM. If i now start the VM, all Network is lost. I must reboot proxmox...
 
	 
	 
 
		