Hi folks,
I have an AMD GPU I'm trying to pass through to a VM to use for Folding@Home. I've done this so far:
amd_iommu=on in the GRUB configuration
added these to /etc/modules:
vfio
vfio_iommu_type1
vfio_pci
vfio_virqfd
update-initramfs -u -k all
rebooted.
The problem is I don't see the GPU in lspci. But if I do a modprobe of amdgpu in the Proxmox host, it loads. Even after doing that, though, I still don't see something that looks like another display controller in lspci. I had this card working fine in an old HP workstation with the same two six-pin power leads connected, so I don't think it's a "you didn't give it enough juice" issue. What am I doing wrong?
I have an AMD GPU I'm trying to pass through to a VM to use for Folding@Home. I've done this so far:
amd_iommu=on in the GRUB configuration
added these to /etc/modules:
vfio
vfio_iommu_type1
vfio_pci
vfio_virqfd
update-initramfs -u -k all
rebooted.
The problem is I don't see the GPU in lspci. But if I do a modprobe of amdgpu in the Proxmox host, it loads. Even after doing that, though, I still don't see something that looks like another display controller in lspci. I had this card working fine in an old HP workstation with the same two six-pin power leads connected, so I don't think it's a "you didn't give it enough juice" issue. What am I doing wrong?
Last edited:
