I did a silly thing and purchased a bunch of systems after reading a few threads on here from unixsurplus. Great price -but... the 2nd NIC on all 4 servers in this Dell system ( 4 boards made by Supermicro - go figure) do not work.There is no MAC address in the bios either... So I am stuck with 1 NIC for each system within this 2 U case Is it possible to use JumboFrames and use the Bridge? My hope is that the virtual serves can talk out and serve data at 1500mtu (normal) while I can use 9000 for the storage array. Sadly I cannot find the expansion cards for these units. can someone give me the For a dummy setup ? I am not a linux admin - but learning . . .
One NIC can I setup VMBR & use Jumbo Frames for the SAN?
- Thread starter herdingcats
- Start date
this should works:
/etc/network/interfaces
/etc/network/interfaces
Code:
auto eth0
iface eth0 inet static
address X.X.X.X
netmask X.X.X.X
mtu 9000
iface vmbr0 inet manual
bridge_ports eth0
bridge_stp off
bridge_fd 0
post-up ifconfig vmbr0 mtu 9000FYI, I tried this approach and it didn't work well for me. My OpenVZ image worked OK, but a KVM vm didn't.
From reading other threads, I set it up like this, and it works:
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet manual
auto vmbr0
iface vmbr0 inet static
address 192.168.240.99
netmask 255.255.252.0
gateway 192.168.243.36
bridge_ports eth0
bridge_stp off
bridge_fd 0
pre-up ifconfig eth0 mtu 9000
When I do an ifconfig, I see MTU of 9000 on both eth0 and vbmr0.
From reading other threads, I set it up like this, and it works:
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet manual
auto vmbr0
iface vmbr0 inet static
address 192.168.240.99
netmask 255.255.252.0
gateway 192.168.243.36
bridge_ports eth0
bridge_stp off
bridge_fd 0
pre-up ifconfig eth0 mtu 9000
When I do an ifconfig, I see MTU of 9000 on both eth0 and vbmr0.