Migration VM using Web GUI and HA

[PSz]

If we want to migrate VM:


we should get information about enabled HA.
Without it migration can be silently reversed and it is very confusing.

Please add to Migrate window information about enabled replication and HA.
Target nodes with active replication should be highlighted, too.

Information about VM RAM size and total disk size will also be very convenient because it allows you to predict the migration time.

 

[PSz]

Additionaly if we want to migrate VM with HA, please add checkbox "[ ] Switch HA rule to ignore state".

 

[justinclift]

Please add to Migrate window information about enabled replication and HA.
Target nodes with active replication should be highlighted, too.

That's a good point, that would indeed be useful.

Specifically because properly operating replication will reduce the "might take long" time to just a few seconds, with nothing perceptible by the end users of the running VMs.