Manual command for applying HA new configuration

AhmedF

Renowned Member
Dec 26, 2012
26
1
68
Hi,

I'm searching for a command line to apply the new cluster.conf configuration after being validated using the following command

Code:
ccs_config_validate -v -f /etc/pve/cluster.conf.new

The documented way is to goto Datacenter then the HA tab, it should show the differences, click Activate to active and sync the config.
am searching for a command to do this from the command line rather then the GUI.

Thanks in advance,
 
Hi Dietmar,

Thanks and this will be synced in all nodes in the cluster automatically ?
 
Sorry is there any service need to be restarted after modifying cluster.conf , tried to restart rgmanager but no effect , didn't catch up the new modification I did with CTs.