Intel X520 Dual Port not showing up in web interface

[Binnih]

Hello.

Just put a Dell Intel X520 Dual Port 10 Gigabit in my homelab proxmox server, fully updated. And it is not showing up in the web interface, just the built in motherboard one.

dmesg | grep ixgbe - shows me that it is fount and set up as far as I can see

-
[ 0.836261] ixgbe: Intel(R) 10 Gigabit PCI Express Network Driver - version 5.1.0-k
[ 0.836262] ixgbe: Copyright (c) 1999-2016 Intel Corporation.
[ 2.016654] ixgbe 0000:09:00.0: Multiqueue Enabled: Rx Queue count = 16, Tx Queue count = 16 XDP Queue count = 0
[ 2.016942] ixgbe 0000:09:00.0: 32.000 Gb/s available PCIe bandwidth (5 GT/s x8 link)
[ 2.017261] ixgbe 0000:09:00.0: MAC: 2, PHY: 1, PBA No: G73129-011
[ 2.017261] ixgbe 0000:09:00.0: b4:96:91:45:ff:f4
[ 2.020026] ixgbe 0000:09:00.0: Intel(R) 10 Gigabit Network Connection
[ 2.020088] libphy: ixgbe-mdio: probed
[ 3.208666] ixgbe 0000:09:00.1: Multiqueue Enabled: Rx Queue count = 16, Tx Queue count = 16 XDP Queue count = 0
[ 3.208954] ixgbe 0000:09:00.1: 32.000 Gb/s available PCIe bandwidth (5 GT/s x8 link)
[ 3.209272] ixgbe 0000:09:00.1: MAC: 2, PHY: 1, PBA No: G73129-011
[ 3.209273] ixgbe 0000:09:00.1: b4:96:91:45:ff:f6
[ 3.212026] ixgbe 0000:09:00.1: Intel(R) 10 Gigabit Network Connection
[ 3.212048] libphy: ixgbe-mdio: probed
[ 3.213057] ixgbe 0000:09:00.0 enp9s0f0: renamed from eth0
[ 3.236751] ixgbe 0000:09:00.1 enp9s0f1: renamed from eth1
[ 18.192180] ixgbe 0000:09:00.0: complete
[ 18.360137] ixgbe 0000:09:00.1: complete
-

But when I log in to the web interface all I see is the 1Gb nic on the motherboard.

And now I am stuck and could use some help please.

 

[Dominic]

Could you post the output of

modinfo ixgbe
ip link