IDrac controller not reachable after bonding eth0, eth1, eth2

[brucexx]

I bonded the eth0, 1, 2 interfaces on my dell server, I have the iDrac controller setup to use the eth0 and the moment I do the LACP on these interfaces I cannot access the iDrac. I am wondering if anybody else is having this issue and maybe if there is a work around.

I do have a dedicated port on teh server but if possible I would prefer to spare ports on the switch.

Thank you

 

[spirit]

you should use enterprise idrac with dedicated port,

AFAIK, embeded idrac on same port than ethX interfaces, is not working with lacp.

 

[brucexx]

Than you that's the answer I was looking for.