[SOLVED] how to configure network when PVS is installed an top of Debian 12

[muekno]

In case of display problems on my DL360 G6 it had to install Debian 12 first, the I followed https://pve.proxmox.com/wiki/Install_Proxmox_VE_on_Debian_12_Bookworm. So far so fine.
In PVE network I see 2 NICs only one is connected, I can not delete the unconnected. I created vmbr0 too looked good so far.
But when I created the first VM it can bot get a DHCP address, DHCP is working fine on my network.

need help

 

[bbgeek17]

Hi @muekno,

You need to provide vastly more information about your bridge configuration, your VM OS, your VM configuration.
You can try to capture DHCP packets on the vmbr and physical interface of the hypervisor to see if the VM sends any, and if any replies come in but don't make it to the VM.
https://unixhealthcheck.com/blog?id=433

---

Blockbridge : Ultra low latency all-NVME shared storage for Proxmox - https://www.blockbridge.com/proxmox

 

[muekno]

Thank you it is Solved. I missed toi set the Bridge Port