Dear all,
Need you help on this:
I have MSA 2060, configured with 2 volumes, connected directly into host with dual port FC Qlogic. Now there are shown in PVE host as 4 drives, but of course there are only 2 (2 volumes configured in MSA).
I've installed multipath, added WWIN, but from there on, not sure what to do more.
In principal, I'm interested in following:
- How to add "vendor specific", for MSA 2060 FC? Are they needed?
How to configure following scenario:
1. Volume 1, by default to use FC QLogic Port 1, if it fails than to go to port 2
2. Volume 2, by default to use FC QLogic Port 2, if it fails than to go to port 1
Finally, as all disks are shown as: /dev/sdd, /dev/sde, /dev/sdf,/dev/sdg, how exactly to use commands pvcreate and lgcreate to create 2 LVM
Thank you very much in advance
Need you help on this:
I have MSA 2060, configured with 2 volumes, connected directly into host with dual port FC Qlogic. Now there are shown in PVE host as 4 drives, but of course there are only 2 (2 volumes configured in MSA).
I've installed multipath, added WWIN, but from there on, not sure what to do more.
In principal, I'm interested in following:
- How to add "vendor specific", for MSA 2060 FC? Are they needed?
How to configure following scenario:
1. Volume 1, by default to use FC QLogic Port 1, if it fails than to go to port 2
2. Volume 2, by default to use FC QLogic Port 2, if it fails than to go to port 1
Finally, as all disks are shown as: /dev/sdd, /dev/sde, /dev/sdf,/dev/sdg, how exactly to use commands pvcreate and lgcreate to create 2 LVM
Thank you very much in advance