Hi, I just activated a dedicated server at iWeb.com, willing to run Proxmox on it, but I'm having a hard time figuring out how to configure networking.
How can I assign one of my IPs to a kvm guest ?
I had to install Proxmox manually, over Debian Sequeeze 64 which they installed.
It is configured with main IP + 6 additional IPs on eth0 ... follows actual info they provided me:
Primary IP address : 174.142.90.46
Primary IP mask : 255.255.255.224
Gateway : 174.142.90.33
Usable secondary addresses: 174.142.92.17-22
Mask : 255.255.255.248
First I tried to add a bridge vmbr0 on port eth0 ... after reboot couldn't reach server anymore.
Tried creating a bridge on IP/Mask ... tried over primary and secondary IPs ... no communication either way.
The only success communications was using NAT, then could reach internet hosts from VM.
So please help me on correct bridge setup ... and what gateway to use on guest (secondary addresses are not on same subnet as primary address).
Thank you!
Paulo Emerique
http://www.esensetec.com.br
How can I assign one of my IPs to a kvm guest ?
I had to install Proxmox manually, over Debian Sequeeze 64 which they installed.
It is configured with main IP + 6 additional IPs on eth0 ... follows actual info they provided me:
Primary IP address : 174.142.90.46
Primary IP mask : 255.255.255.224
Gateway : 174.142.90.33
Usable secondary addresses: 174.142.92.17-22
Mask : 255.255.255.248
First I tried to add a bridge vmbr0 on port eth0 ... after reboot couldn't reach server anymore.
Tried creating a bridge on IP/Mask ... tried over primary and secondary IPs ... no communication either way.
The only success communications was using NAT, then could reach internet hosts from VM.
So please help me on correct bridge setup ... and what gateway to use on guest (secondary addresses are not on same subnet as primary address).
Thank you!
Paulo Emerique
http://www.esensetec.com.br