Hey,
currently I'm facing some problems with my new setup. Heres my setup.
Now I have some problems with my IPv6 connection. In first place everything looks fine but my Gateway-Monitor in my Opnsenses deliver continuesly 100% package lost. But when I try to make an nslookup or a ping with ipv6 everything looks good and there is no error in the output. When I try to connect to the internet via IPv6 with one of my containers in the vnets everything looks good as well. When I try to access my machines from the internet over the load balancer sometimes I get an connection error. It seemed that this only appears on my IPv6 connections. So I think that I have an error which I could not see directly.
Here are some screenshots of my Interfaces-File. The file looks exactly the same on both PVEs (exp. the ip addresses for sure). I already compared my full opnsense configs to each other and here are the settings the same as well (exp. ip-address range)
WAN Interface Configuration in Opnsense:
Gateway Configuration in Opnsense:
I dont use Tracking Interfaces with my public IPv6 subnet because I would create an failsafe environment. If I set IPv6-Adresses from both of my Inetnet Connections to the clients in the vnets I could potentially get connection problems when one of the opnsense or the pve dies.
Hope that someone could see the problem.
currently I'm facing some problems with my new setup. Heres my setup.
Now I have some problems with my IPv6 connection. In first place everything looks fine but my Gateway-Monitor in my Opnsenses deliver continuesly 100% package lost. But when I try to make an nslookup or a ping with ipv6 everything looks good and there is no error in the output. When I try to connect to the internet via IPv6 with one of my containers in the vnets everything looks good as well. When I try to access my machines from the internet over the load balancer sometimes I get an connection error. It seemed that this only appears on my IPv6 connections. So I think that I have an error which I could not see directly.
Here are some screenshots of my Interfaces-File. The file looks exactly the same on both PVEs (exp. the ip addresses for sure). I already compared my full opnsense configs to each other and here are the settings the same as well (exp. ip-address range)
WAN Interface Configuration in Opnsense:
Gateway Configuration in Opnsense:
I dont use Tracking Interfaces with my public IPv6 subnet because I would create an failsafe environment. If I set IPv6-Adresses from both of my Inetnet Connections to the clients in the vnets I could potentially get connection problems when one of the opnsense or the pve dies.
Hope that someone could see the problem.