Configure bonding over bonded interface

Fala

New Member
Dec 24, 2014
6
0
1
| .....................+----eth0---sw1
|.......+----bond0+----eth1---sw1
bond2
| ......+----bond1+----eth2---sw2
| .....................+----eth3---sw2

Bond0 - balancing-xor
Bond1 - balancing-xor
Bond2 - active-backup

Is it possible?
 
Last edited:
I tested this config and not working.

Work perfect this config:

| .....................+----eth0---sw1 RSTP
|.......+----bond0+----eth1---sw1 RSTP
vmbr0
| ......+----bond1+----eth2---sw2 RSTP
| .....................+----eth3---sw2 RSTP

Bond0 - balancing-xor
Bond1 - balancing-xor
vmbr0 - Bond0, Bond1, STP ON


However, in the simulation of a network failure for a single node, the node is fenced.


Reconstruction of the STP takes about 20 seconds.


Any ideas?
 

About

The Proxmox community has been around for many years and offers help and support for Proxmox VE, Proxmox Backup Server, and Proxmox Mail Gateway.
We think our community is one of the best thanks to people like you!

Get your subscription!

The Proxmox team works very hard to make sure you are running the best software and getting stable updates and security enhancements, as well as quick enterprise support. Tens of thousands of happy customers have a Proxmox subscription. Get yours easily in our online shop.

Buy now!