Hi,
I'm using Proxmox ton manage a router with 2 physical Ethernet interfaces. One of the VM is pfSense which is used to route/firewall my home LAN. During installation, I use the interface which will be LAN for pfSense. But once pfSense is up and running, I can't acces to proxmox WegGUI. I have to put a 3rd interface (simple USB/eth adaptator) to be able to manage proxmox.
Here is my setup :
- WAN (eno1) vmbr0, no IP => assigned to pfSense only
- LAN (enp2s0) vmbr1, 192.168.0.11/24 => assigned to pfSense plus all other VM
- USB (enx9) no bridge, 192.168.0.10/24 => not assigned to any VM
From my LAN, I ping LAN interface (192.168.0.11) only if USB interface (192.168.0.10) is plugged.
I would like to remove the USB interface but I can"t. Any advice on my configuration ?
Thank you very much,
Regards,
gUI
I'm using Proxmox ton manage a router with 2 physical Ethernet interfaces. One of the VM is pfSense which is used to route/firewall my home LAN. During installation, I use the interface which will be LAN for pfSense. But once pfSense is up and running, I can't acces to proxmox WegGUI. I have to put a 3rd interface (simple USB/eth adaptator) to be able to manage proxmox.
Here is my setup :
- WAN (eno1) vmbr0, no IP => assigned to pfSense only
- LAN (enp2s0) vmbr1, 192.168.0.11/24 => assigned to pfSense plus all other VM
- USB (enx9) no bridge, 192.168.0.10/24 => not assigned to any VM
From my LAN, I ping LAN interface (192.168.0.11) only if USB interface (192.168.0.10) is plugged.
I would like to remove the USB interface but I can"t. Any advice on my configuration ?
Thank you very much,
Regards,
gUI