I just installed a SUPERMICRO AOC-STGN-i2S in my 5018D-FN4T.
PCI passthrough is working fine for a VM.
1. How do I add this interface to pve with the system already setup?
I imagine if I was doing a fresh install of pve, this card would get added in udev by some process of setup.
What command can I exec to do the same process post install?
I know I can init the lines for a new iface in /network/interfaces, but there has to be more to it than that.
I'm not savvy about udevadm, not sure what the systemd predictable name would be for this card.
Anyone have any experience with adding intel x520 cards after install?
Reposted from Networking forum because maybe my decision to post in there was wrong. This may be a better fit.
PCI passthrough is working fine for a VM.
1. How do I add this interface to pve with the system already setup?
I imagine if I was doing a fresh install of pve, this card would get added in udev by some process of setup.
What command can I exec to do the same process post install?
I know I can init the lines for a new iface in /network/interfaces, but there has to be more to it than that.
I'm not savvy about udevadm, not sure what the systemd predictable name would be for this card.
Anyone have any experience with adding intel x520 cards after install?
Reposted from Networking forum because maybe my decision to post in there was wrong. This may be a better fit.
