ospf

Hi. I'm working on automating my homelab setup with Ansible and the PVE API. I'm using the new SDN fabrics in PVE 9, and I've been able to set up my OSPF fabric manually. However, when I try to do the same with the API I get a bit stuck. I'm able to create a fabric node if I don't specify...

Please add the “cost” parameter in SDN/Fabrics for OSPF/interfaces. The manually added “cost” parameter is removed after modification from the GUI.

Currently I have a VLAN SDN zone setup with 3 nodes in it. I also have FRR setup on each node that is supposed to use OSPF to get its default gateways from some upstream routers, however, on the routers the neighbor state doesn't change from 'Init' indicating that there isn't bidirectional OSPF...

Setup Overview: - Two virtual routers that run VyOS setup on Dell servers with an Anycast gateway configured between them that allows all other VMs to use either one as their default gateway. - The virtual routers run OSPF and share routes with two upstream Mikrotiks, which then share routes...

Hi there, This is a bit of an edge case, though being so short on time it's taking me a while to understand the inner workings of IPv6. There's a reason they say "throw out your understanding of v4 as it has no bearing with v6", holy moly are they right! It's great but needs to be understood...