multipath-tools
-
O
lvm filter configured but multipath underlying device still in use
Hi all, I have three server machines, each connected to a SAS array. One server has two paths, two servers only have one, as my DS3524 only has four SAS ports in total. I'd like to expand its setup in the future to support two paths from each machine, but for the time being I'm setting up each...- oasis9
- Thread
- boot device busy device-mapper lvm2 multipath-tools sas
- Replies: 5
- Forum: Proxmox VE: Installation and configuration
-
L
The server does not start the network if multipatch is in autoload [fixed]
Hello installed proxmox 7.0-10 (clean install), set up multipatch and everything works! but if it reboots, then the network does not start, you can raise the network after executing the "/etc/init.d/networking restart". If you turn off the autoload of the multipatch-tools, then everything loads...- larry77
- Thread
- multipath-tools network
- Replies: 1
- Forum: Proxmox VE: Networking and Firewall
-
R
Multipath-tools Errors in PVE 6.3 Updated
Hi, I have install and configure 3 Nodes Cluster Proxmox Virtual Environment 6.3-3 with multipath-tools Installed: 0.7.9-3+deb10u1 and seeing following errors continuously. multipathd[10763]: get_alua_info: get_asymmetric_access_state returned -3 multipathd[10763]: sdi: couldn't get...- Rais Ahmed
- Thread
- multipath multipath-tools multipathd pve 6.3-3
- Replies: 7
- Forum: Proxmox VE: Installation and configuration