masquerading

I'm pretty new to Proxmox (I've successfully set it up before but not using masquerading). I'm trying to set the network up so that all of the traffic is routed from the Proxmox IP to one of the VMs which is running HAProxy, so that it can send that traffic onto whatever backend should handle...

Please help. I did it like here (Masquerading) https://pve.proxmox.com/wiki/Network_Configuration. i have only one public IP. Proxmox version 6.4-1. $ cat /etc/network/interfaces auto lo iface lo inet loopback auto ens3 iface ens3 inet static address XXX.XXX.XXX.171/24 gateway...

Hello, I am running Proxmox VE 8.1 and I find myself in a really difficult situation regarding NAT. Important to mention: I already searched through Proxmox documentation and similar issues here on the forum but I didn't find anything that matched my specific case, or that, with a few tweaks...

Greetings, I am trying to make my containers have access to internet through proxmox host public ip. Below are my proxmox host networking configurations. ``` auto lo iface lo inet loopback iface eno1 inet manual auto eno4 iface eno4 inet manual iface eno2 inet manual iface eno3 inet...

https://pve.proxmox.com/wiki/Network_Configuration#sysadmin_network_masquerading I'm currently using this setup because my hosting provider gives me a single IPv4 address, so I have to set up masquerading. I'm setting up a new Proxmox host, and I'm considering adding IPv6 configuration from...

Greetings I'm configuring a new Proxmox host which unfortunatly will have to run on a single IP, so I need masquerading for incoming connections. I used to do that with a custom iptables script, but I wonder if I can do it directly with the Proxmox firewall GUI? Thanks in advance Regards

Hi, I have some problems getting the LXC firewalls managed by Proxmox to work. This is my pve setup: auto lo iface lo inet loopback iface enp9s0 inet manual auto vmbr0 iface vmbr0 inet static address xxx.xxx.xxx.227/32 gateway xxx.xxx.xxx.193 bridge-ports enp9s0...

I'm trying to set up Proxmox in a way that all VMs would use the same interface with manual port forwarding. I found this post that pretty much describes what I want to achieve: https://forum.proxmox.com/threads/how-to-config-same-ip-for-all-vm.34748/post-170333 But sadly it's rather...

Hello I setup the third proxmox-machine. There I have network issues. I doublechecked everything, but still didn't find my mistake yet. I'm sure it's just a little thing to fix. On Container: floh@container01:~$ ping 8.8.8.8 PING 8.8.8.8 (8.8.8.8) 56(84) bytes of data. From 10.10.10.1...

I have 3 windows vms with one single shared IP address how do I setup the networking to share this address? At the moment the virtual nic is showing but I don't know how to configure any of the rest of it.

Hi, Please forgive me if this is slightly off topic, but the synergy is strong... I have a KVM server running Debian 9.2. There are two guests, one straight FreeBSD 11.1, the other pfSense 2.4.2 (also FreeBSD 11.1). The KVM server has a NIC on the local LAN, and it's got a software bridge...