I hope for the help of the forum because I have been trying unsuccessfully for some time to install the iGPU driver for AMD Ryzen 5650GE.
I followed the guide vom this thread Link , but i got i lot of errors - you see in the post.
Has anyone had success with the driver installation? If so, I...
Hi, I just finished doing uid and gid mapping on a non-privileged container for gpu passthrough and the container boots fine.
This container will run jellyfin and yes I know they say to use privileged containers but for security reasons I couldn't.
I got to the point where it says to install the...
I am absolutely new to proxmox (and linux as well)
I have an AMD R5 270X GPU installed, and assigned to a vm. The passthrough is working fine (used parsec to access the vm after adding the gpu). After started installing the AMD graphics driver, the vm frozen, and could no longer access it...
Hi all, i was wondering if anyone has had any luck finding/configuring/installing a k1 grid gpu in their proxmox setup.
it would be greatly appreciated if anyone could explain where to access the correct drivers for proxmox.
Currently running Proxmox 8.2.2
Dell r720
Nvidia K1 Grid Gpu
I'm currently using an up to date version of Promox 8 and this version includes mpi3mr 8.5.1.0.0:
root@pvetemp:~# uname -a
Linux pvetemp 6.8.4-3-pve #1 SMP PREEMPT_DYNAMIC PMX 6.8.4-3 (2024-05-02T11:55Z) x86_64 GNU/Linux
root@pvetemp:~# pveversion
pve-manager/8.2.2/9355359cd7afbae4 (running...
Good afternoon, all,
I have recently upgraded to proxmox 8, on ym three IBM iDataPlex dx360 m4's. I have been attempting to configure a 10gb connection via SFP from the Mellanox Connectx cards to my unify 16 port SFP switch. I have been successful getting a link light between the two, but I...
Hello everyone,
It's a couple days I'm struggling with a Windows Server 2016 migration. Here what I've done:
Installed VirtIO drivers on the phisical srv (even if probably it's useless)
Exported a qcow2 image with Starwind P2V Converter
Imported the qcow2 on proxmox and created a vm with...
Due to a missing storage controller driver, my Windows VM is unable to start up.
To resolve this, I must add the vioscsi-driver to the startup process of Windows. But how?
Although I am able to manually load the driver and access the system disk through the recovery command prompt, but the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.