disconnect

I have been experiencing an issue with one of the nodes i just joined to my cluster. It was in an old cluster and worked perfectly fine. For some reason in this new cluster i keep getting this issue. I am able to get the error to explain itself when i'm migrating a vm so that's why in the...

Hi Proxmox folks, I have two external SSDs which I'm trying to connect to my Proxmox node via USB 3.0 to SATA cables. However, I'm seeing behaviour where I have one of them plugged into the USB 3.0 port running just fine, but when I plug the other one in, the first one disconnects :( Here are...

Amigos presento problema con una caja de discos Orico de 4 Discos, conectada a proxmox por USB la cual a su vez va conectada a una maquina virtual con openmediavault. Mi servidor proxmox presenta el siguiente log el cual me reinicia la conexión USB y la máquina virtual pierde la comunicación...

Hi guys Recently I started using USB for the first time on my system, I want to use a zigbee USB stick which doesn't go well at all. The plan was to use a LXC for this but couldn't get it to work after a lot of trying I have discovered something strange. In the BIOS, I have disabled USB 3.0...

Hello. i have a problems with USB devices in container. All devices works perfectly by passthrough to container. Udev rules are written e.g. /dev/1wire From time to time i must do a manually reconnect of a device. After reconnect the USB device is not responsible in container. Rebooting...

Proxmox 6.4 Asus X570-e Motherboard Amd 5800x cpu 64GB ram I am running their linux version within proxmox itself (no container/vm). Using this 64 bit installer - https://www.cyberpowersystems.com/product/software/power-panel-business/powerpanel-business-4-4-0-linux/ . The issue is...

Hello Proxmox Forum, I have since I installed proxmox permanently problems that after x amount of days apparently my ssds are offline or abort the connection and thus my complete proxmox setup crashes. I have installed the ssds normally and direct on the sata ports in the server where proxmox...

Hi everybody, I'm getting an issue with my Proxmox v5, I create a new interface to use the nat method, however, after restarting the network all VMS is disconnected to the internet. my interface configure below auto lo iface lo inet loopback iface ens33 inet manual auto vmbr0 iface vmbr0...

I have a pfsense VM running on proxmox that handles Internet and routing. Proxmox is configured with dual NIC (one LAN, one WAN) and two linux bridges that are tied to the specific physical interfaces Internet / pfsense works just fine until I want to use the internet on the proxmox server...