Search results

Yes I understand that now. It's quite simple when you understand it properly. In this mode if you added the network card to your vm it would be like 'passing through' the network card directly, so to speak. But only that device would have access to it, hence the creation of Bridges in the...

So thinking further the vmbr's should just be seen as unmanaged switches then. All the routing/DNS is being done between the vm and the actual physical router. Hypothetically then you could do the same for vmbr0 and the vm's would still reach the Internet, just the host Proxmox would not be...

So you are saying just set the gateway of 192.168.44.15 inside my vm and it will reach the router? Obviously the vm will have DNS also set to 192.168.44.15 So I don't need to do this now? And also remove all IP addressing from vmbr1 and vmbr 2?

Then how will those vmbr's know how to reach the Internet without a route and no gateway?

No, no load balancing. I require complete isolation between the vm's on each bridge/router. Yes I want the vm's on each bridge/route to go through the respective router only, with no chance of going anywhere else. I have services on each vm/bridge that require the same incoming ports open...

I have 3 NICS connecting to separate Routers and out to separate Internet connections. I have set up the additional bridges vmbr1 and vmbr2, given them the required subnets and linked them to the physical NICS, see screenshot. vmbr0 has the 'Default Gateway' on it, and I know I cannot put...

I cannot see any way of doing it from the GUI. I might be able to do it from the command line. I have gone ahead and added the 2 lines into my VM 'conf' file for the 2 partitions. This does seem to work perfectly. They show up in OMV as dev/vda1 and dev/vdb1, (virtual disks I guess). I have...

Hi, I have an OMV setup as a QEMU virtual machine in Proxmox. I want to pass through a physical disk to the virtual machine. I have the command to do that:- qm set 104 -virtio2 /dev/disk/by-id/ata-WDC_WD6003FFBX-68MU3N0_V8G3xxxx I should also say that I created 2 partitions first on this...

Thanks Dominik. I'll do some more tests.

Dominik, why would the 'Move' GUI option do different things when used at different times? The latest attempt did this:- drive mirror is starting for drive-scsi0 drive-scsi0: transferred: 0 bytes remaining: 107374182400 bytes total: 107374182400 bytes progression: 0.00 % busy: 1 ready: 0 The...

I wanted to move a VM disk image on a hard disk LVM Thin volume to an SSD LVM Thin volume, because it was too slow on the hard disk. I used the GUI Move option to move it, but once it was moved it was no longer a used space of 23GB but had expanded up to the full provisioned size of 100GB. I...