Search results

I am using Kernal 2.6.32, i havnt raided the machine i havnt had the IRQ issue, as the machine is plugged into a KVM switch, although i will be looking at a clustered setup in the near future.

Sorry Tom, I was ment to say raid 5, although i may put extra disks in for this. I know that each virtual machine would create a virtual hard disk file. I know that the installer would put the proxmox OS onto one of the hard disks. What i want to do is have a raid array just for the...

Hi Tom, Im building a sandybridge system with an i7 2600k and 16gb ram, what i wanted to to was to put a single hard disk and then set up a raid 10 with 3 600Gb raptors. Is it possible to have the virtual machine disks stored on the raid array, and the proxmox os on the single disk.

Is it possible in proxmox to say if i had two disks to store the disk images on a separate drive?

I have seen some SSDs used with ESXi and the results a pretty solid. This was using the first generation intel SSD's, i would like to try out some that use the sandforce controller as they have a better I/O throughput. With the disk images on one disk i wouldn't be so sure if the write usage...

I was considering putting one disk on the motherboard for Proxmox and then a raid for the VM images. Possibly a raid 10 with 4 drives or a 3 drive raid 5. I not too sure what would give me the best performance. Ijust want a little bit of fault tolerance. As it is only going to be a VM for...

Cool i assume it works fine you didn't have to track down any drivers. I also the motherboard you have as it uses the GPU on the motherboard would use some system ram for graphics. would you have any recommendations for raid cards, as i assume the intel raid on board isn't up to much.

I Am looking at setting up a box for testing. I am looking at getting the Asus P8P67 Motherboard with the i7 2600k and 16GB Ram. Would this be a good base to start with, is anyone using sandy bridge with proxmox?