Search results

Hey StearsOfWar! Just ran into the same problem, and found your post while looking for answers. Did you end up resolving by any chance?

Argh - solved it! Just had to persist with the research. For anyone else with similar problems: enx644bf02b0b57 was my virtual NIC via USB-c. I just had to switch out the bridge to work with enp88s0 instead (the ethernet connection).

So, I have been running a home Proxmox install for a couple of years on a NUC 11 with no issues - running Ubuntu, Home Assistant and a few other bits and pieces. Bit of an amateur with regards to Linux and Networking, but have typically gotten by without too many hiccups. My setup was due for a...

Hi all, I have an existing NUC set up with proxmox for use with two nodes: 1) Home Assistant 2) Ubuntu/Plex/Unifi network controller The system was hacked together pretty quickly and I've lost track of steps taken and considerations, however I have gotten to the point of running out of disk...

Fair enough - thanks so much for your help. I'll make sure to review those logs next time I hit a snag. As you said - all up and running so no problem now! I suspect it may have been something to do with bootable drives, OVMF, EFI disks based on additional tinkering, but could be wrong

By co-oincidence, just had a big storm blow through. I woke up, and we had lost power at some point - NUC was powered down. Booted her up and - the second VM spun up fine! Is this expected behaviour? e.g. should I have to reboot the host to trigger effective VM behaviour? Or was this just a...

Great, thanks! I hadn't figured that out. This is the result: Error: Unknown device type. can't create interface fwln101i0 - command '/sbin/ip link add name fwln101i0 mtu 1500 type veth peer name fwpr101p0 mtu 1500' failed: exit code 2 kvm: -netdev...

Hi, Complete beginner here, so apologies in advance. I am new to Proxmox, having just set up a NUC with a first VM running Home Assistant. I managed to follow some guides to correctly configure the initial VM with no issues - it is operating as expected. I am now trying to spin up a second...