Search results

Any news on this? Did a total clean reinstall and still the same

Good point @Dunuin . I'm already happy that it works, but the error stays and also the Boost Active is stil on no....

With the help of Level1Techs Forum and setting the cTDP manully, I now get the correct frequencies. Can be closed.

driver: acpi-cpufreq CPUs which run at the same hardware frequency: 0 CPUs which need to have their frequency coordinated by software: 0 maximum transition latency: Cannot determine or is not supported. hardware limits: 1.50 GHz - 2.73 GHz available frequency steps: 2.20 GHz, 1.50...

Thanks, @tom ! That bumped the speed up to 2734MHz, still 1GHz to go.....Shall I report this in the 5.11 kernel thread?

Yesterday I installed a fresh Proxmox node on my new server with an AMD Epyc Milan processor. During first install, I got the following error message: pve kernel: [Firmware Bug]: ACPI: Invalid BIOS _PSS frequency found for processor 0: 0x0 MHz This repeated itself for every core (32 in total)...

Clear that I don't install Cloud-init anymore on the host. Will re-install Proxmox, VM backups pulled from the current install. Thanks for the help!

Well.....It should have been on the DebianTest VM, wanted to make my own Template VM. Might have done it in the wrong putty window....:oops: Any way to fix this?

Changed 127.0.1.1 to 10.0.1.60 in the /etc/hosts file, rebooted, problem still exists. Opened /etc/hosts again and IP address was again at 127.0.1.1: cat /etc/hosts # Your system has configured 'manage_etc_hosts' as True. # As a result, if you wish for changes to this file to persist # then...

OK. My network is in de 10.0.1.x/24 range, Proxmox should get a static IP of 10.0.1.60. So I have to replace 127.0.1.1 with 10.0.1.60?

OK, don't recall changing that, can you elaborate on what to change? Non-loopback ip doesn't ring a bell with me, I'm afraid.

output of systemctl status pve-cluster.service: pve-cluster.service - The Proxmox VE cluster filesystem Loaded: loaded (/lib/systemd/system/pve-cluster.service; enabled; vendor preset: enabled) Active: failed (Result: exit-code) since Wed 2021-05-26 14:19:22 CEST; 29min ago Process...

Agree, Comporder1. Very strange that there are build-in options to backup and replicate VM's, LXC, etc, but not the Proxmox host. Now facing the second time Proxmox installation suddenly broke, no way to recover it but a complete reinstall.

Did a reboot yesterday of my single-node Proxmox installation and after the powercycle, Proxmox won't properly boot any more. I get an error message stating'Failed to start Proxmox VE cluster filesystem' and to check 'systemctl status pve-cluster.service'. After a few minutes I get a login...