Search results

Try to replace switch.

А свитч какой? Гигабит или сотка? What type of switch? 1 Gbps or 100 Mbps?

First suggest, wait for 5.0 release. Second, try to burn Proxmox ISO onto CD/DVD.

@CashewCaliphate, FYI, this was described in numbers of articles around the Web.

Logs shows follows: lxc_conf - conf.c:setup_hw_addr:2144 - ioctl failure : Cannot assign requested address lxc-start 20170620111030.883 DEBUG lxc_conf - conf.c:setup_hw_addr:2146 - mac address 'f9:78:23:47:38:15' on 'eth0' has been setup lxc-start 20170620111030.883 ERROR lxc_conf -...

KVM VM or LXC container is isolated system and cannot connect directly to Proxmox host usual way (tcp port, unix socket, etc.) Please provide more info on your setup.

Well, all the problems resolved so easy :-) Very glad for that! Always at your service. Live long and prosper. :-)

What DHCP ip address range is defined in your router?

It is possible and it depends on how your router is tuned. You can check something like 'Firewall' settings on your router. It seems that IP address, mask and default gateway settings on your Proxmox are correct, and if you can reach Proxmox by network, then physical network is fine. Then, we...

Another reason of such behavior is that you can have IP address conflict: two identical IP addresses at same network. Please check that too.

Maybe your router 192.168.1.1 has any of reject filters that now allow Proxmox to send packets outside. Can you check that?

Uptade to at least 3.4 and use NoVNC console which faster, accessible from any browser and no needed for Java.

Make sure you have enough free space on your storage and inside VM. Try to replace virtio disk device to IDE.

The best solution for you is add third hardware node, not VM node. I think configuration you want to use can be correct, but you lose all cluster features, i. e. centralized nodes control, migration, etc.

Did you try to play with UEFI/Legacy boot modes?

Why you cannot boot your Proxmox? What's the problem?

Братуха, с мультикастом нормально всё? Is there no problems with multicast?

Also,as I remember, there were issues with several switches. Please upgrade your switch firmware. I have had some troubles too, remember, with VLAN configuration and multicast. As a result, I have had to move cluster network to dedicated network interfaces on each node and connect it to separate...

Instead of separate nodes, you can use two-node cluster configuration. I know, that it is not recommended, but it works.

Please show 'ip addr', 'ip route' and 'traceroute 8.8.8.8' commands output.