Search results

Hi ! I deployed a LXC container and installed the ezarr suite : https://github.com/Luctia/ezarr So the config part uid/gid are set : drwxrwxr-x 8 13013 13000 4096 Nov 19 10:14 bazarr-config drwxrwxr-x 3 13008 13000 4096 Nov 19 10:14 jackett-config drwxrwxr-x 4 13003 13000 4096 Nov 19 14:15...

Thanks for the help @dcsapak , I thought I tried it when it was shut down, but apparently not. It works now.

Thanks @dcsapak , here is in attachment the requested outputs. note that the current usb device is spice, as I cannot set the correct one

Hi ! I have a usb device that I would like to attach to a VM. It was working previously, but now the pci passthrough does not work with the message : "Parameter verification failed. (400) usb1: hotplug problem - VM 102 qmp command 'device_add' failed - usb port 2 (bus xhci.0) not found (in...

This has to be done on the node where you connect to. and refresh the browser !

Thanks @leesteken, I did read the doc, but I did not understand it properly. Thanks for the help ! This works now.

Hello, I've tried this, but still IOMMU is not detected. My device is a NUC8i3BEH. I could not figure out what I did wrong

Hi, also you can use "ceph osd crush remove fiorito"

The issue on the HP N54L is resolved with 17.2.7

The issue on the HP N54L is resolved with 17.2.7

is there an install ISO available to update with the fix ?

I hope there will be some improvements here, as it seems to be the same issue with the AMD N40L/N54L : AMD Turion(tm) II Neo N40L Dual-Core Processor and AMD Turion(tm) II Neo N54L Dual-Core Processor No new firmware now

Thanks ! would you advice to get back to 7.4 ? (if supported? )

Hi I've recently upgraded from 7.4 to 8.0. I have a cluster of 5 nodes, and 2 have the below failed condition. I mention that these two are HP N54L. All ceph-related process are failing like this : 0> 2023-06-28T12:19:08.096+0200 7f5efbaf3a00 -1 *** Caught signal (Illegal instruction) **...

is there a public official documentation for this procedure ? Thanks

for reference, the fstab (/etc/fstab) entry will correspond to : [mon1]:6789,[mon2]:6789:/ /mnt/cephfs ceph name=[user]

I've found out that the radosgw service was not running on any nodes ... solving this resolved the issue.

I have the same behavior

Another view would be to delete them all and loose the data. What would happen to a RBD if some pg are removed ? does it crash or something ? Thanks for sharing any idea / experience.

Hi Everyone, Thank you first for taking time to read this post. I seek for help, as I was not able to get around this situation. This blocks the two main pool of my cluster to become active :( I've seen this post https://forum.proxmox.com/threads/ceph-osd-crashed.114137/#post-493297, and...