Search results
-
B
Proxmox requires full reboot after shutting down VM with PCI passthrough
I've noticed this behaviour with a NIC (Broadcom BCM57810S) interface passed through to my OPNsense or pfSense routers and the enp1s0f0 / enp1s0f1 interface didn't show up again until 1) VM is not enabled at bootup using the passthrough interface 2) proxmox is rebooted to clear usage of...- bolmsted
- Post #10
- Forum: Proxmox VE: Installation and configuration
-
B
PVE7.1 - rebuild kernel module "invalid module format", "Skipping invalid relocation target, existing value is nonzero for type 1"
Hello I'm trying to rebuild a kernel module (bnx2x) with some custom changes and have done this in the past in PVE6.x without issue but now I'm getting "invalid module format" when I'm trying to load the kernel module and I'm getting these last few messages in dmesg related to "Skipping invalid...- bolmsted
- Thread
- Replies: 0
- Forum: Proxmox VE: Installation and configuration
-
B
Intel i350-T4(V2??) card not showing up in Proxmox VE
Did you ever figure this out? I have a QLogic Broadcom BCM57810S dual port SFP+ card and a Quad port Intel i350-t4 card (supposedly, yes aware of the potential counterfeit but bought from a local place (via ebay) that says was a Dell version). For some reason on my first proxmox install I...- bolmsted
- Post #4
- Forum: Proxmox VE: Networking and Firewall