Search results

As a new member I am very late on this thread but in case you haven't found a way try this https://www.reddit.com/r/homelab/comments/rhq56e/displaying_cpu_temperature_in_proxmox_summery_in/ I have successfully been able to have this show up following the directions

I appreciate you taking the time to point out areas that will improve my installation I am new to Proxmox and what little I know I have gleaned from googling or watching youtube videos not from first hand knowledge. With regards to "Note that ballooning is not possible when doing PCI passthrough...

After re-reading you response several times, I believe you hit on the problem which was caused on my end. I did in fact have the "all function" checked on both enp4 ports. When I unchecked them and then added them they worked as expected.

Attached is the information you requested. This anomaly is not consistent . Last night after trying to add then delete then add then delete I was finally able to get it to work properly (enp4s0f0 and eno4s0f1 side by side). Tried again this morning and it didn't work, I left it that way so...

Hopefully I can clearly explain my situation. I have an intel NIC with 4 ports: enp4s0f0 enp4s0f1 enp5s0f0 enp5s0f1 When I try to add enp4s0f0 as a pci device all is fine and the vm boots. When I add enp4s0f1to the mix the vm won't boot and when I go back to enp4s0f1 in the vm instead of being...

First, thanks for the reply, your first paragraph is where I was struggling and still am. By stating "connect your physical WAN NIC" are you referring to the virtual WAN bridge created in proxmox and should this be connected to one of the 48 ports on the hp switch (connect to ISP router}...

I want to setup a homelab and in the process gain more networking knowledge. Currently I am using a Unifi DreamMachine as the router, a HP JE009A V1910-48G switch (overkill for me but was <$40.00 on ebay) a Dell T5600 with 2 E5-2680 cpu's (16coresx32 threads), 32gb memory and 6 ethernet ports...

Of course it would be that obvious. I was looking at previous version tutorials were it was more intuitive (at least for me -:). Thank you for your quick reply

I am new to proxmox so sorry if the answer is obvious, but I can't figure out how to do a daily (7 day) vm backup at a specified time. When I go to the proxmox gui there are no options that meet this requirement