Search results

yes i did that

i followed all your instructions, but im not getting a wan address on pfsense. is that normal? shouldnt i have to plug the modem into the server? can i just unplug it from the switch and plug it into the other server port?

so i had it working, screwed it up, did everything the same as before but now i cant get it to give me a connection outside of my network. im going to try it following your steps, but should i be doing this with bridge mode enabled on the modem right from the start? as in, bridge mode>install...

I got it working! But lost connection to proxmox web gui when I put the modem into bridge mode. Changed the IP address to the new network through command line in hosts and network interfaces, but typed the wrong gateway now I have no connection again lmao

no, i'm in canada on shaw internet i've got 2 switches, but im only using one at the moment. i have the modem/router plugged into the server right now and server plugged into the switch. i've got unifi access points, but as of right now, with the modem plugged into the server and not the...

do i NEED to use passthrough? is there not a way to just install and set it up as is without having to passthrough anything, so the host "router" is the server/pfsense vm, modem is connected to server sfp+ port 1, server to switch through sfp+ port 2? i've legit had it running using that setup...

i have sr-iov enabled and i followed the instructions to passthrough with sr-iov as well. did some searching and says to change the number to echo 64 for this nic, then added file to /etc/sysfs.d/ - "echo 64 > /sys/bus/pci/devices/0000:03:00.0/sriov_numvfs" is what i used

i still have the old 1gb 4 port nic that the server came with. as i said when i posted the pictures, i can plug it in on the opposite side of the bracket of the 10g nic, but it sits about 2" back from the back of the server. like the port plug is recessed quite a bit further, so i wasnt sure if...

yeah i followed that guide for the setup as well, but once i get in to the web gui, create my firewall rules to allow traffic, set up dhcp server etc... then boot my isp router into bridge mode i lose all connection to my network and have no way of getting back into the isp modem/router settings...

i think blacklisting the nic driver killed my connection

ahh ok well i tried doing the passthrough again last night and i can no longer get into the web gui or ssh lol. so i've gotta figure out how to get in there or reverse everything i did i guess

this is what i get when i update initramfs

oh so its fine if i dont have it enabled?

all i can find on csm for my server is legacy mode? is that what i need to enable? because ahci is enabled by default

k ill look into this csm thing and ill try the passthrough again with my subscription active and report back haha