Search results

Hi all, Im trying to figure out if my controller has the IT firmware. 1. Drives are in none RAID and it shows HBA in BIOS. 2. Proxmox can see separate drives and i can do whatever with them. 3. When i passthrough the controller to TrueNAS it wont even get to install complaining about some...

Nope... it just doesnt seem to care... im ordering new modules, just dont understand why would intel not allow use of CISCO modules... Stupid bastards...

Im sure there is EFI partition. If we cant solve it i will have new modules by Tuesday.

There is not such a file. in etc/kernel/ only ones there are install, postinst and postrm. Should i create one? Any way to check what is it using? As when the same think works on other debians i dont see reason why it wouldnt work here.

I think Dunuin is correct.

Kind of new to all this. U are most likely right. What would be the commands for updating command line after edit? Thank You so much!

Did u try to boot to proxmox install go ALT+CTRL F2 or F1 and try to clean the drive by removing partitions? Did u have it installed on the same drive last time? I did hit similar problem on reinstall, when I used dual SD module. Turned out there were read/write issues with card. Check the drive...

1. Check you installation target 2. You CANT BOOT FROM NVMe! unless it U.2 and u have the upgraded backplane.

Hi I´v got this problem with unsupported module. My system is Dell R720 with the i350/X520 integrated NIC. There used to be workaround like this, that for some reason doesnt work for me!!! PLEASE HELP. Or do i have spend more money on transceivers? I have 10GbE CISCO MM LC, that so far worked...