zenny's latest activity
-
Zzenny reacted to wahmed's post in the thread OpnSense on Proxmox with Virtio Drivers - A Success story with
Like.
Have you tried e1000 virtual network interface instead of virtio? I have few virtualized firewalls deployment based on pfSense. Since OPNsense is a fork of pfSense, they should behave similarly. I avoid using openvswitch bridge for perimeter or... -
Zzenny replied to the thread Proxmox Installation – SSD Not Detected.I had the same issue. The SSD gets detected with other OS except Proxmox9. It was detected by Proxmox7 earlier. Even `lsblk` did not detect the SSD!
-
Zzenny replied to the thread [SOLVED] Gigabit NIC gives only 100Mbps: Intel 82576 Gbit NIC with igb kernel module.I did check with other computers and switches and still the issue persists. Seems like there must be something wrong with either with the connectors or the cable itself. Anyway thanks for your attention and suggestion. Cheers,
-
Zzenny replied to the thread [SOLVED] Gigabit NIC gives only 100Mbps: Intel 82576 Gbit NIC with igb kernel module.I have switched to the Cat5.E patch cable and the Gigabits started working. # ethtool enp2s0f0 Settings for enp2s0f0: Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full...
-
Zzenny posted the thread [SOLVED] Gigabit NIC gives only 100Mbps: Intel 82576 Gbit NIC with igb kernel module in Proxmox VE: Networking and Firewall.Hi, I installed PM9 using the default installer. I have 2 Gigabit NICs built-in in Supremicro H8DGU mobo as of below and I am connected only to a single port: # lspci | grep -i Ethernet 02:00.0 Ethernet controller: Intel Corporation 82576...