VictorSTS's latest activity
-
VictorSTS replied to the thread Minimum permissions for users for file restore.Be careful: that would allow a user to download any file from the VM, including sensitive information that normally is protected by the OS and it's permissions, not to mention the ability to see the retention policy of backups which can be used... -
VictorSTS replied to the thread Adding a New Server to Existing Proxmox Cluster - Network Configuration and VM Communication.Nothing personal at all and wasn't meant to be rude with the OP in any way. Sorry if it looks like that. Thanks for pointing it out. I've been there too: tasked with a job that could not do because I lacked knowledge/experience/practice. What OP...
-
VictorSTS replied to the thread Adding a New Server to Existing Proxmox Cluster - Network Configuration and VM Communication.You could read the documentation so you can give your CEO an informed opinion about what should be done and how to properly deploy Proxmox software. Again, if in doubt, refer your CEO to a partner or ask for official training [1]. A very...
-
VictorSTS reacted to zikou's post in the thread Adding a New Server to Existing Proxmox Cluster - Network Configuration and VM Communication with
Like.
I guess this is a task that should be done by senior because Im junior devops -
VictorSTS replied to the thread Adding a New Server to Existing Proxmox Cluster - Network Configuration and VM Communication.No, a PVE node can't be on different providers. As stated in the link I sent you before [1], nodes must be at max 10ms from each other, IME being under 5ms is recommended. Maybe you could use professional support on this and/or training, please...
-
VictorSTS replied to the thread Rebooting one node causes other node to reboot.Supermicro Twin? Ceph wise I would create a custom crush map to define a "chasis" level and ensure that a single chasis will not hold two copies. Replace "migh" with "will" for around one third of your PGs. It's a fact, not a chance ;). The...
-
VictorSTS replied to the thread Rebooting one node causes other node to reboot.Are you planning on shutting down 3 of your servers often or are you simply planning for a "just in case 3 servers break"? On the first case, use a qdevice somewhere (PBS is fine, although I also install PVE in my PBS servers and prefer to use...
-
VictorSTS replied to the thread VM was silently skipped for backup with: config locked (backup).When you backup a VM, it's config is locked so no change can be made until backup is done. When a backup task doesn't end properly (user stops it, destination full and the likes), PVE does not clean the status properly (yet) and the VM stays in...
-
VictorSTS replied to the thread dirty-bitmap status: existing bitmap was invalid and has been cleared - every.single.time!.IMHO it's better to use PBS sync to copy backups from one PBS to another instead of doing backup of the VM multiple times, even if PVE could use multiple dirty-maps for a few PBS. Less load on source PVE, less load on VMs and you offload the...
-
I've created a Bugzilla entry for this. Linking it here in case anyone is interested.
-
VictorSTS replied to the thread pve-cluster service wont start.Would be nice if you provided that little detail ;) For reference, there is a long thread regarding host name change with different procedures, some for older versions [1] You probably had some configurations in the host too. Some combinations...
-
VictorSTS replied to the thread pve-cluster service wont start.Have you changed the host's name? What's in your /etc/hostname and /etc/hosts ?
-
VictorSTS replied to the thread LVM-Thin can be used in multiple-node clusters?.No, you can't use LVM-Thin with a shared LUN, as LVM-Thin uses metadata for things like snapshots and thin provision. If you configure your shared LUN with LVM-thin you will end up with data corruption sooner than later. If your storage supports...
-
Were moved to the 4 node setup, thank you guys. Also i have tested the "client" only join and yes, its working without any configuration, i only had to join to the PVE cluster and the CEPH storage which is defined in the cluster get available on...
-
VictorSTS replied to the thread Help !!! Question about remove Datastore (free up space?).You can always use something like scp or sftp to copy some files to your PC, then use my step by step recovery method [1]. Once some space is recovered, copy the files back to the same location they were. [1]...