Noch mal: Wenn du wirklich große Angst hast dir alles kaputt zu machen, dann mache vorher am Besten ein Backup des ganzen Systems (womit auch immer, aber clonezilla ist vergleichsweise narrensicher, braucht halt eine externe Platte) und teste ob...
Ich bin Freund von gebrauchten Intel DC Festplatten von eBay. Diese sind zuverlässig, gut, und oft sogar günstiger als neue Consumer Festplatten wenn < 500G. Das andere kann ich dir leider nicht beantworten.
Well..., yes.
As soon as one of two nodes is unavailable you cannot administrate the single survivor - it will deny everything with "no quorum". Just try it!
There are workarounds for disaster recovery: "pvecm expected 1" will probably work...
Ja, aber ich würde auf jeden Fall vorher ein Backup oder Snapshot machen. Snapshots sind mit zfs trivial, für ein Backup könnte man clonezilla nehmen. Und wie Maxim würde ich die Finger von inoffiziellen Tools lassen, nicht nur beim Updaten
Why I need this? Simple: I have only a single node and that single node runs pve and pbs. It's a soho situation.
And indeed I need to do 'dangerous' things. I have to resize LVM volumes.
root@pve:~# lsblk
NAME...
@kamanwu Depending on the installation stage, you could be able to switch to other virtual console with pressing keys Alt F1 or Alt F2 or Alt F3 etc. and receive shell command line.
Just a few ideas, this is not a comprehensive list by far:
turn power off / shutdown
pull the power cord - yes, I mean it
check all cabling: pull and reseat all connectors - on both ends
turn on...
Only if lsblk lists all devices (except one...
Hey folks,
I got asked to cross-post this to the Proxmox forums. You might already know me from the ProxLB project for Proxmox, BoxyBSD or some of the new Ansible modules for Proxmox and I just published a new open-source tool: ProxCLMC (Prox...
Just guessing: make sure that name resolution works correctly. Usually by a full blown DNS server (possibly overkill) or (simpler) by maintaining a consistent /etc/hosts, containing all host names and addresses of all hosts. That file should be...
You could run systemctl stop proxmox-backup-proxy.service proxmox-backup.service... and no backup is possible anymore, as far as I can see.
For PVE (and active HA) there is ha-manager crm-command node-maintenance enable pveX .
And PVE itself...
Ja.
Nein.
Ein erfolgreiches Verify bestätigt, dass das Backup unverändert und vollständig zur Verfügung steht, also vom PBS vom Massenspeicher gelesen werden kann.
Während der Sicherung wurden Checksummen berechnet, die auch dauerhaft...
I did that, too following detailled instructions at https://pve.proxmox.com/wiki/Upgrade_from_8_to_9 and had no issues at all
I recommend changing the thread‘s title to something meaningful to gain more attention.
Well, I (often) emphasize "my" to state clearly that it is not a neutral statement, resulting from of a large field study, but my personal one.
We all try to give some helpful hints to the readers of this forum, I believe. And it is normal that...
you can give the PVE access token only access to read old backups and create new ones, but not remove/prune backups. you can combine this with a sync job on the PBS side to keep an offsite archive that is decoupled from the main PBS system (with...
Leider habe ich keinen konkreten Hinweis; du erwähnst nicht, ob du diese Seiten bereits kennst:
https://pve.proxmox.com/wiki/Windows_10_guest_best_practices
https://pve.proxmox.com/wiki/Advanced_Migration_Techniques_to_Proxmox_VE#HyperV
Viel...
Your attitude is surprising, and frankly, unnecessary. I'm happy to tell you why. Otherwise you can totally ignore this reply - It'll be my final one regardless as I have nothing else to add to this thread.
I didn't have to report back, but I...
Yes, a lot of setups will reach end of life before a cheap (non-PLP) SSD may die. At least you may hope for that. To increase the reliabilty drastically my rule is to use redundancy and to use "with-PLP" devices.
Disclaimer: I do not follow my...
I agree, especially since TrueNAS not only supports the Apps from the app store but also allows setting up containers with docker-compose files. Most applications in the self-hosted sphere already provide ones for copy/paste. Or like you said...