Recent content by tranermr

Sure enough, that did it! Thanks! And wow - that's a downright historic install!

Yep, the SHA256 hashes for both the 18.04 and 20.04 ISOs match the ones provided by Ubuntu. It must be something with my configuration that is causing the instability during installation, but I'm stumped as to what it could be.

Thanks for your feedback and suggestions! I've tried it in the past with the default hwscsi setting (LSI 53C895A for me) but I encounter the same issue. I hadn't tried it with SPICE for a graphics card, so I reset to the default values except for the graphics, but same issue unfortunately...

Sure! For the 18.04 version that worked: (Notably, it only worked once - I've tried again with the same settings and it fails during the install) qm config 102 bootdisk: scsi0 cores: 6 ide2: local:iso/ubuntu-18.04.4-live-server-amd64.iso,media=cdrom memory: 10240 name: SteamHost net0...

Update: I was able to install 18.04 and boot successfully using default BIOS, display, machine, and changing only the SCSI COntroller to the VMware PVSCSI. However, this doesn't seem to replicate for 20.04; I still have installation failures partway through.

Hello all, I am attempting to install Ubuntu 20.04 (though I am encountering the same issue on Ubuntu 18.04) on Proxmox 6.2-4, however the installation usually fails partway, and on rare occasions when it does complete the VM hangs on "Booting from Hard Disk" I've tried peoples'...

Nevermind, I was able to activate the interface using "ip link set dev enp3s0f0 up", and then discovered that the ethernet ports were numbered opposite the way in the diagram I had been looking at using "ip link show up". Thanks!

Hello, I have seen numerous threads on this issue, but I haven't been able to get their solutions to work. Thanks for your patience! I have Proxmox free configured on an i7 system, and just added a quad port intel NIC card to the machine, and plan to only use the original NIC for management...