Recent content by tomte76

  1. T

    Kernel panic caused by skbuff

    I did some more research but didn't really get any further. Any ideas how to proceed? At times I disabled the VM's firewalls and hope it's stable now.
  2. T

    Kernel panic caused by skbuff

    The problem has occurred again. I think it looks very similar. However, different interface to other VM. I have now switched off the firewalls on the VM and hope that this will make it more stable. Any ideas what else I could do? Here is the stack trace: [362086.626721] skbuff: skb_under_panic...
  3. T

    Kernel panic caused by skbuff

    Could it be related to IPv6 or dualstack? In both of the dumps I have, I can see a lot of references to IPv6 like: [451923.472465] reject_tg6+0xa3/0x100 [ip6t_REJECT] [451923.478443] ip6t_do_table+0x2e5/0x870 [ip6_tables] [451923.490508] ip6table_filter_hook+0x1a/0x20 [ip6table_filter]...
  4. T

    Kernel panic caused by skbuff

    Unfortunately the problem still occurs. In the meantime there was a few months of silence, but now the server has stopped several times within 10 days. So I set up a netconsole and found the following dump: [451923.338181] skbuff: skb_under_panic: text:ffffffffafcc27db len:74 put:14...
  5. T

    Kernel panic caused by skbuff

    Many thanks for the answer. I have to admit that I don't really know anything about kernel development. But I also didn't want to just write an entry in the forum without having done at least a little research. I'm sorry if that caused confusion. In any case, I use virtio drivers in all VMs. And...
  6. T

    Kernel panic caused by skbuff

    I also experience kernel crashes since I migrated to Proxmox 7. 3 times in 2 weeks. No changes to hardware compared to Proxmox 4. Just a fresh installation. memtest already ran. HP iLO shows good system health. Unfortunately, my system is then inaccessible and does not write any corresponding...
  7. T

    pveproxy: problem with client xxx.xxx.x.xxx; ssl3_read_bytes: ssl handshake failure

    I have the same problem. I suddenly appeared out of nowhere. No reboot or anything. We have a eight node cluster and this only happens if I connect to the first node in the cluster which we are using as the "Web-UI-Host". If I connect to the second one everything works fine. I also restarted...
  8. T

    GRUB error on reboot - device not found

    Additional research substantiated the assumption that the problem is related to the disk geometry. A closer view to the raid parameters with HP SmartStart showed, that the created RAID0 arrays and logical drives have a Sector/Track setting of 32. I checked some plain SATA disks and found a...
  9. T

    GRUB error on reboot - device not found

    Yes. I understand. Thank you. So the interest in debugging the issue is low. I did a last proxmox 5.1 installation after wipeing all disk in a separate system without RAID controller to ensure all blocks are wiped. Still the same behavior. I'll attach two screenshots from grub with debug all...
  10. T

    GRUB error on reboot - device not found

    HP P410i. The disks are exported as a RAID0 each, because P410i is not able to do JBOD. I now understand, that it is not supported. But I am still wondering why it worked before for a long time and stopped working now. Need to have a look if it is possible to connect the backplane to another HBA...
  11. T

    GRUB error on reboot - device not found

    I meanwhile nulled all disks on the server, installed latest bios, raidcontroller firmware, disk firmware. Then I did a clean install with Proxmox 5.1 latest ISO. Install works fine, but the system is not able to boot. Same error as before. Are you interested in debugging this issue? I could...
  12. T

    GRUB error on reboot - device not found

    ok. I'm wondering why it was possible to boot the machine at least 7 times after updates (according to our system documentation) since it was installed but now it won't boot up again and seems to remain "unfixable". When I do a "set debug=all" in grub and then try to do e.g. an "ls (hd0)" I can...
  13. T

    GRUB error on reboot - device not found

    Thank you. Unfortunately I have no spare disk slots or space on existing disks to set up a separate boot partition. I'll backup the data now with zfs send. Does the recommendation to have a non-zfs /boot partition mean, that it is not recommended to boot from ZFS any more? The I woul take to...
  14. T

    GRUB error on reboot - device not found

    tried downgrading grub without success. tried recreating /etc/zfs/zpool.cache and update initramfs without success. scrubed rpool without any error reinstalled grub on all devices afterwards tried to boot from all disks by setting the bootdisks error is still the same Any other ideas except...
  15. T

    GRUB error on reboot - device not found

    interesting. using an older proxmox 4.4 iso and rescue boot does not work. It cannot find rpool. If i boot ubuntu 17.10 and do a "zpool import rpool" everything works fine.

About

The Proxmox community has been around for many years and offers help and support for Proxmox VE, Proxmox Backup Server, and Proxmox Mail Gateway.
We think our community is one of the best thanks to people like you!

Get your subscription!

The Proxmox team works very hard to make sure you are running the best software and getting stable updates and security enhancements, as well as quick enterprise support. Tens of thousands of happy customers have a Proxmox subscription. Get yours easily in our online shop.

Buy now!